Reason Analysis on Early Failure of Rear Axle Gear for Heavy Truck
摘 要
重型汽车后桥主减速器齿轮在较短使用时间内发生了严重磨损和局部掉块的情况, 通过对主、被动齿轮的化学成分、硬度、硬化层深度、宏观和微观组织进行了检验和分析, 确定了后桥齿轮失效的主要原因为过载和润滑不良。
Abstract
The serious wear and local chipping occurred on the main reducer gears of rear axle for heavy truck after using in a relatively short time. By means of the test for chemical composition, hardness, hardening layer depth of initiative and passive gear, the main failure reasons of rear axle gear was confirmed for the overload and insufficient lubrication.
中图分类号 TH132.41
所属栏目 质量控制与失效分析
基金项目
收稿日期 2013/9/13
修改稿日期
网络出版日期
作者单位点击查看
备注弋楠(1983-),男,讲师,在读工程硕士。
引用该论文: YI Nan,YANG Jian. Reason Analysis on Early Failure of Rear Axle Gear for Heavy Truck[J]. Physical Testing and Chemical Analysis part A:Physical Testing, 2014, 50(7): 518~521
弋楠,杨健. 重型汽车后桥齿轮早期损伤原因分析[J]. 理化检验-物理分册, 2014, 50(7): 518~521
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】钢铁热处理编写组.钢铁热处理[M].上海: 上海科学技术出版社, 1979.
【2】上海机械制造工艺研究所.金相分析技术[M].上海: 上海科学技术文献出版社, 1987.
【3】张栋.失效分析[M].北京: 国防工业出版社, 2004.
【2】上海机械制造工艺研究所.金相分析技术[M].上海: 上海科学技术文献出版社, 1987.
【3】张栋.失效分析[M].北京: 国防工业出版社, 2004.
相关信息