燃机过渡段螺栓原位超声波检测试验
In-Situ Ultrasonic Testing for Bolt of Gas Turbine Transition Section
摘 要
为实现LNG电厂燃机过渡段螺栓原位超声波检测，深入分析了螺栓的几何结构及受力状况，并对模拟试样进行了系统的检测试验。发现合适的直探头具有足够的灵敏度检测螺栓六角头下端面存在的1 mm及以上的横向裂纹，而螺栓其余位置的横向裂纹需使用合适的小角度纵波探头进行检测。最终通过结合使用5P8×12的12°纵波斜探头和5P6直探头成功完成对该种螺栓的原位超声波检测。
螺栓
燃机
Ultrasonic testing
Bolt
Gas turbine
Abstract
To achieve in situ ultrasonic testing for bolts of gas turbine transition section in LNG gas turbine power plant, the structure and stress state of bolt were intensively studied in this paper, and simulation samples were tested. It was found that crosswise crack with longer than or equal to 1mm on the lower surface of bolt hex head could be found by single-straight probe, and crosswise crack on other position could be found by small angle longitudinal wave probe with right angle. Finally it was concluded that bolts of gas turbine transition section could be comprehensively detected by using 5P8×12, 12° small angle longitudinal wave probe and 5P6 single-straight probe.
中图分类号 TG115.28
所属栏目 实践经验
基金项目
收稿日期 2011/5/31
修改稿日期
网络出版日期
作者单位点击查看
备注冯尚龙(1979-)，男，硕士，主要从事电力系统金属设备无损检测工作。
引用该论文: FENG Shang-Long,CHEN Chao-Yang,CHEN Kai-Lu,HUANG Cheng-Feng. In-Situ Ultrasonic Testing for Bolt of Gas Turbine Transition Section[J]. Nondestructive Testing, 2012, 34(5): 81～83
冯尚龙,陈朝阳,陈开路,黄承锋. 燃机过渡段螺栓原位超声波检测试验[J]. 无损检测, 2012, 34(5): 81～83
共有人对该论文发表了看法，其中：
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】李树军.底波遮挡法在螺栓超声波探伤中的应用［J］.河北电力技术,2001,1(20):45-49.
【2】夏纪真.液压缸紧固螺栓的原位超声波探伤［J］.无损探伤,1999(1):40-41.
【3】刘英和，康泰.游乐设施高强度螺栓小角度纵波探伤［J］.无损检测,2005,2(27):105-109.
【2】夏纪真.液压缸紧固螺栓的原位超声波探伤［J］.无损探伤,1999(1):40-41.
【3】刘英和，康泰.游乐设施高强度螺栓小角度纵波探伤［J］.无损检测,2005,2(27):105-109.
相关信息
