添加剂对镁铝合金微弧氧化作用的研究
EFFECT OF ADDITIVE ON MICROARC OXIDATION OF Al-Mg ALLOY
摘 要
通过对电解液特性测试和微弧氧化膜成分、结构和性能的试验,研究多元醇基的E11和E12添加剂加入铝酸盐和钼酸盐混合电解液体系后镁铝合金微弧氧化膜的性能及其微弧氧化工艺.结果表明镁铝合金在NaAlO2＋NaMoO4+E11＋E12复合电解液体系中微弧氧化电流为3-5A、电解液温度不超过35℃、溶液电阻率3.5Ω·m:镁铝合金微弧氧化膜主要由MgO、MgAl2O4和Al12Mg17组成,其腐蚀速率比基体降低2个数量级以上,加入添加剂后的微弧氧化膜较不加添加剂的更加均匀、致密.
微弧氧化
添加剂
Magnesium aluminum alloy
Microarc oxidation
Additive
Abstract
The characteristics and technology of Al-Mg alloy microarc oxidation were investigated in the mixed electrolyte solution of aluminate and molybdenate including E11 and E12 alcoholate additives.The microarc current was in the range of 3-5A,the solution temperature was below 35℃,and the solution conductivity was greater than 3.5Ω·m for NaAlO2＋NaMoO4+E11＋E12 mixed solution.The oxide film of Al-Mg alloy was composed of MgO,MgAl2O4 and Al12Mg17,and its corrosion rate was much slower than the matrix.The microarc oxidation film was uniform and compact in the solution with additives.
中图分类号 TG178
所属栏目 试验研究
基金项目 江苏省自然科学基金(BK2005020)和中国矿业大学校基金项目(ON4528)
收稿日期 2006/2/18
修改稿日期 2006/2/28
网络出版日期
作者单位点击查看
引用该论文: WANG Yang,SHEN Cheng-jin,MIAO Yao-jun. EFFECT OF ADDITIVE ON MICROARC OXIDATION OF Al-Mg ALLOY[J]. Corrosion & Protection, 2006, 27(8): 387～390
共有人对该论文发表了看法，其中：
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】Yeroklin A L,Nie X,Leyland A,et al.Plasma electrolysis for surface engineering[J].Surface Coatings Technol,1999,122:73-93.
【2】Verdier S,Boinet M,Maximovitch S,et al .Formation structure and composition of anodic films on AM60 magnesium alloy obtained by DC plasma anodizing[J].Corrosion Science,2005,47:1429-1444.
【3】Zozulin A J,Bartak D E.Anodized coatings for magnesium alloys[J].Met Finish,1994,92(3):39.
【4】薛文斌,来永春,邓志威,等.镁合金微等离子体氧化膜的特性[J].材料科学与工艺,1997,5(2):92-95.
【5】蒋百灵,张先锋,朱静.铝合金镁合金微弧氧化陶瓷层的形成机理及性能[J].西安理工大学学报,2003,19(4):297-302.
【6】卫中领,陈秋荣,丁翠红,等.镁合金微弧氧化膜的微观结构及耐蚀性研究[J].材料保护,2003,36(10):21-23.
【7】Mironova M K.Formation of film in anodic microarc oxidation[J].Protection of Metals,1990,26(2):255-258.
【8】龚巍巍,张乐,吴晓玲,等.镁合金等离子体微弧氧化过程的研究[J].材料热处理学报,2005,26(1):77-80.
【2】Verdier S,Boinet M,Maximovitch S,et al .Formation structure and composition of anodic films on AM60 magnesium alloy obtained by DC plasma anodizing[J].Corrosion Science,2005,47:1429-1444.
【3】Zozulin A J,Bartak D E.Anodized coatings for magnesium alloys[J].Met Finish,1994,92(3):39.
【4】薛文斌,来永春,邓志威,等.镁合金微等离子体氧化膜的特性[J].材料科学与工艺,1997,5(2):92-95.
【5】蒋百灵,张先锋,朱静.铝合金镁合金微弧氧化陶瓷层的形成机理及性能[J].西安理工大学学报,2003,19(4):297-302.
【6】卫中领,陈秋荣,丁翠红,等.镁合金微弧氧化膜的微观结构及耐蚀性研究[J].材料保护,2003,36(10):21-23.
【7】Mironova M K.Formation of film in anodic microarc oxidation[J].Protection of Metals,1990,26(2):255-258.
【8】龚巍巍,张乐,吴晓玲,等.镁合金等离子体微弧氧化过程的研究[J].材料热处理学报,2005,26(1):77-80.
相关信息
