预处理及氧化工艺对阳极氧化铝膜结构有序度的影响
Influence of Preprocessing and Two-step Anodization on Anodic Aluminum Oxide Template
摘 要
采用硫酸阳极氧化工艺制备了多孔阳极氧化铝膜,采用扫描电子显微镜对多孔氧化铝膜的形貌进行表征.分别讨论了高温退火和二次氧化对多孔阳极氧化铝膜多孔结构的有序度的影响.试验结果表明,高温退火和二次氧化对提升阳极氧化铝膜的结构有序度起了很大作用.
制备纳米有序阵列
模板
工艺
alumimum anodic oxidation
nano-scale ordered array
template
fabrication process
Abstract
Porous anodic alumina film was prepared in sulfuric acid electrolyte and scanning electron microscope(SEM)was used to observe the surface morphology.The effect of preprocessing and two-step anodization on anodic alumina film was investigated respectively.The experimental results indicate that the well ordered porosity resulted from the preprocessing and two-step anodization.
中图分类号 TG178 TB383
所属栏目 试验研究
基金项目
收稿日期 2007/7/4
修改稿日期 2007/7/20
网络出版日期
作者单位点击查看
引用该论文: LI Ning,XU Qi-ming,ZHANG Wen-yan,FU Jia. Influence of Preprocessing and Two-step Anodization on Anodic Aluminum Oxide Template[J]. Corrosion & Protection, 2008, 29(7): 389～390
共有人对该论文发表了看法，其中：
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
相关信息
