搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
常温下镁锂合金浸锌溶液及一次浸锌
          
Zinc Once Dipping and Its Solution for Mg-Li Alloy at Normal Temperature

摘    要
为了在常温下对镁锂合金表面进行浸锌,采用有机酸盐络合剂在传统浸锌溶液基础上制备新型浸锌溶液,对镁锂合金表面进行一次浸锌研究.采用扫描电子显微镜、电化学分析仪对一次浸锌层的微观形貌和电化学性能进行分析,结果表明常温下利用新型浸锌溶液可在镁锂合金表面得到细小、致密均匀的一次浸锌层,浸锌时间为5 min时锌晶粒基本覆盖了镁锂合金表面,并且此时镁锂合金的腐蚀电位正移幅度最大,腐蚀电流最小,容抗弧半径、溶液电阻和电荷转移电阻最大,镀镍层耐腐蚀性好,与基体的结合力最好,说明一次浸锌5 min时效果最佳.
标    签 镁锂合金   一次浸锌   常温   浸锌时间   有机酸盐络合剂   Mg-Li alloy   zinc once dipping   normal temperature   immersion time   organic acid salt complexing agent  
 
Abstract
The traditional zinc dipping solution was modified with organic acid salt complexing agents to immerse zinc on Mg-Li alloy at normal temperature.Zinc once dipping on Mg-Li alloy surface was studied.SEM and electrochemical analyzer were used to analyze the micromorphology and electrochemical performance of the zinc once dipping layer.The results showed that the zinc once dipped layer obtained on Mg-Li alloy in new zinc dipping solution at normal temperature was fine,compact and homogeneous.The layer obtained at 5min mostly covered the Mg-Li alloy surface,which demonstrated the most positive corrosion potential,minimal corrosion current,largest radius of capacitive loops,electrolytic resistance and charge transfer resistance.The nickel-plate on the zinc dipped layer showed good corrosion resistance,and its adherence to Mg-Li alloy matrix was the best.

中图分类号 TG178 TQ153.1

 
  中国光学期刊网论文下载说明


所属栏目 应用技术

基金项目 国家自然科学基金资助项目(50603003)

收稿日期 2007/11/19

修改稿日期

网络出版日期

作者单位点击查看

引用该论文: SHENG Nan,ZHANG Chun-hong,HUANG Xiao-mei,GAO Li-li. Zinc Once Dipping and Its Solution for Mg-Li Alloy at Normal Temperature[J]. Corrosion & Protection, 2008, 29(12): 752~755


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】Li J F,Zheng Z Q,Li S C,et al.Preparation and galvanic anodizing of a Mg-Li alloy[J].Materials Science and Engineering,2006,433:233-240.
 
【2】魏世丞,徐滨士,付东兴,等.军用装备镁合金表面防腐蚀技术研究[J].装甲兵工程学院学报,2006,20(6),79-83.
 
【3】Amadeh A,Pahlevani B,Heshmati-Manesh S.Effects of rare earth metal addition on surface morphology and corrosion resistance of hot-dipped zinc coatings[J].Corrosion Science,2002,44:2321-2331.
 
【4】Kouisni L,Azzi M,Zertoubi M,et al.Phosphate coatings on magnesium alloy AM60 part 1 study of the formation and the growth of zinc phosphate films[J].Surface and Coatings Technology,2004,185:58-67.
 
【5】Kouisnia L,Azzia M,Zertoubia M,et al.Phosphate coatings on magnesium alloy AM60 Part 2 Electrochemic behaviour in borate buffer solution[J].Surface and Coatings Technology,2004,185:58-67.
 
【6】Gray J E,Luan B.Protective coatings on magnesium and its alloys-a critical review[J].Alloys and Compounds,2002,336:88-113.
 
【7】郭洪飞,安茂忠.镁及镁合金电镀与化学镀[J].电镀与环保,2004,24(2):1-5.
 
【8】Jueling Chen,Gang Yu,Bonian Hu,et al.A zinc transition layer in electroless nickel plating[J].Surface & Coatings Technology,2006,201:686-690.
 
【9】Yusuke Kowase,Nabeen K Shrestha,Tetsuo Saji.Preparation of coloured composite films of Ni/organic pigments by immersion plating over zinc surface[J].Surface and Coatings Technology,2006,200:5526-5531.
 
【10】宋光铃.镁合金腐蚀与防护[M].北京:化学工业出版社,2006.
 
相关信息
   标题 相关频次
 镁锂合金在模拟人体体液中的腐蚀
 4
 Mg-14Li-1Al-0.1Ce合金在NaCl溶液中的腐蚀行为
 3
 EA4T车轴钢中斑点状偏析的原因分析
 2
 LA141镁锂合金表面微弧氧化热控膜层的制备
 2
 LZ91镁锂合金双相结构表面的化学镀镍过程
 2
 常温钢铁多功能磷化液
 2
 超轻镁锂合金强化方法的研究现状
 2
 超声测强技术在混凝土结构强度验收中的应用
 2
 钢铁的常温磷化液配方优选
 2
 一种复合磷化促进剂对常温锌系磷化液性能的影响
 2
 3A21铝合金在乙二醇水溶液中的腐蚀行为
 1
 LZ92镁锂合金激光焊接接头的显微组织与力学性能
 1
 NaCl对Q235钢早期腐蚀行为的影响
 1
 澳大利亚发现超强耐腐蚀镁锂合金材料
 1
 钡盐改性常温锌钙系磷化液
 1
 钡盐改性清洁型常温锌锰系磷化液
 1
 不锈钢氧化皮常温清洗膏
 1
 常温铁系磷化工艺研究
 1
 常温铁系磷化液
 1
 复合常温磷化促进剂研究
 1
 环保型钢铁常温发黑剂的研制
 1
 挤压和轧制对两相共存镁锂合金组织与性能的影响
 1
 科学家发明纳米工厂 常温生产半导体纳米晶体
 1
 六价铬的分析方法研究进展
 1
 镁锂合金表面化学镀镍工艺
 1
 免水洗常温锰系磷化膜的制备与性能
 1
 氢对铸态Mg-14Li合金表面形貌和力学性能的影响
 1
 陕西研制出目前最轻金属结构材料
 1
 一种新型的不锈钢氧化皮常温快速清洗液
 1
 一种新型钢铁表面常温“四合一”除油除锈磷化液
 1