搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
2197铝锂合金在不同热处理状态下的晶间腐蚀及剥蚀行为
          
Intergranular Corrosion and Exfoliation Corrosion Behaviors of 2197 Al-Li Alloy with Different Aging Treatments

摘    要
研究了T6和T8态两种时效状态下的2197铝锂合金的晶间腐蚀和剥蚀行为.结果表明,随时效时间延长,晶界T1相数量及晶界无沉淀带宽度增加,合金晶间腐蚀和剥蚀敏感性增加;更低的时效温度和时效前的预变形,促进T1相析出,并使无沉淀析出带宽度减小,因此T8态的耐蚀性优于T6态.通过电化学阻抗谱可准确地判断合金的剥蚀敏感性,由此判断出的剥蚀发生时间和剥蚀敏感性与通过剥蚀照片观察的结果一致.
标    签 2197铝锂合金   晶间腐蚀   剥蚀   电化学阻抗谱   2197 Al-Li alloy   intergranular corrosion   exfoliation corrosion   electrochemical impedance spectruscopy  
 
Abstract
The intergranular corrosion and exfoliation corrosion behaviors of 2197 Al-Li alloy with T6 temper and T8 temper were investigated.The results show that with the increase of aging time,the number of T1 phase and precipitate-free zone(PFZ) at grain boundaries increased,and the susceptibility to intergranular corrosion and exfoliation corrosion was enhanced.The corrosion resistence of the alloy under T8 condition was better than that under T6 condition,because lower aging temperatured and pre-deformation prior to aging promoted T1 phase precipitation and minimize PFZ at grain boundaries.The susceptibility to exfoliation corrosion estimated by the electrochemical impedance spectruscopy(EIS) was the same as the one estimated by exfoliation photograph observesion.

中图分类号 TG172 TG146.2

 
  中国光学期刊网论文下载说明


所属栏目 试验研究

基金项目 民口配套项目:(MKPT-2004-19ZD)

收稿日期 2008/12/22

修改稿日期 2009/2/2

网络出版日期

作者单位点击查看


备注郑子樵,博士生导师.

引用该论文: CHEN Yuan-yuan,ZHENG Zi-qiao,WEI Xiu-yu,PAN Zheng-rong,LI Shi-chen. Intergranular Corrosion and Exfoliation Corrosion Behaviors of 2197 Al-Li Alloy with Different Aging Treatments[J]. Corrosion & Protection, 2010, 31(1): 29~33


被引情况:


【1】马灿,谭澄宇,覃思思,李杰,蒋建辉, "时效对7056铝合金在EXCO溶液中剥落腐蚀行为的影响",腐蚀与防护 37, 93-99(2016)



论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】杨守杰,陆政,苏彬,等.铝锂合金研究进展[J].材料工程,2001,(5):44-47.
 
【2】HE Jian-ping,CHEN Wen-li,XU Wei,et al.Effect of exfoliation on structure and tensile st rength of LC4CS aluminium alloy at constant temperature[J].Journal of Nanjing University of Aeronautics and Astronautics,1999,31(5):575-579.
 
【3】HE Bin,SUN You-chao,FAN Wei-xun.Influence of exfoliation corrosion on the fatigue of aluminium alloy[J].Journal of Nanjing University of Aeronautics and Astronautics,1998,30(3):306-310.
 
【4】GB 7998-1987.Standard test method for intergranular corrosion susceptibility in Al alloys[S].
 
【5】ASTM G34-1979.Standard Test Method for Exfoliation corrosion susceptibility in 2××× and 7××× series aluminium alloys(EXCO test)[S].
 
【6】JIANG Na,LI Jin-feng,ZHENG Zi-qiao,et al.Effect of aging on mechanical properties and localized corrosion behaviors of Al-Cu-Li alloy[J].Trans Nonferrous Met Soc China,2005,15(1):23-29.
 
【7】张匀,朱自勇,王政富,等.铝锂合金的晶间腐蚀和剥落腐蚀行为[J].中国腐蚀与防护学报,1992,12(2):180-184.
 
【8】Buchheit R G,Moran J P,Stoner G E.Electrochemical behavior of T1(Al2CuLi) intermetallic compound and it s role in localized corrosion of Al-2 % Li-3 % Cu alloys[J].Corrosion,1994,50(2):120-130.
 
【9】Kumai C,Kusinski J,Thomas G,et al.Influence of aging at 200 ℃ on the corrosion resistance of Al-Li and Al-Cu-Li alloys[J].Corrosion,1989,45(4):294-302.
 
【10】Keddam M,Kuntz C,Takenouti H,et al.Exfoliation corrosion of aluminum alloys examined by electrode impedance[J].Electrochimica Acta,1997,42(1):87-97.
 
【11】曹楚南,王佳,林海潮.氯离子对钝态金属电极阻抗频谱的影响[J].中国腐蚀与防护学报,1989,9(4):261-270.
 
【12】Conde A,Damborenea J de.Evaluation of exfoliation susceptibility by means of the electrochemical spectroscopy[J].Corros Sci,2000,42(8):1363-1377.
 
【13】Conde A,Dambonea J de.Electrochemical modelling of exfoliation corrosion behavior of 8090 alloy[J].Electrochimi Acta,1998,43(8):849-860.
 
相关信息
   标题 相关频次
 2E12铝合金的疲劳性能与裂纹扩展行为
 4
 单级时效7056铝合金的显微组织与性能
 4
 Cl-浓度对2A12铝合金电化学行为的影响
 3
 冷变形量及稳定化处理对5083铝合金耐腐蚀性能的影响
 3
 时效制度对含钪超高强铝合金晶间腐蚀和剥落腐蚀的影响
 3
 18-8奥氏体不锈钢焊接接头晶间腐蚀的评定及控制
 2
 2219铝合金母材及焊接接头的腐蚀行为
 2
 2B96K铝锂合金剥蚀过程的电化学阻抗研究
 2
 304L不锈钢在硝酸工业环境中的长周期腐蚀行为
 2
 304奥氏体不锈钢管焊接接头开裂原因
 2
 304奥氏体不锈钢护栏断裂失效分析
 2
 304不锈钢薄壁容器焊缝腐蚀泄漏原因
 2
 304和316L管材在两类模拟介质中的晶间腐蚀形貌
 2
 316L-16MnR复合板不锈钢侧晶间腐蚀原因分析
 2
 5083铝合金的耐晶间腐蚀性能
 2
 6156铝合金疲劳裂纹的扩展速率
 2
 7075-TiB2原位铝基复合材料的腐蚀性能
 2
 800H合金旋风分离器壳体失效分析
 2
 9Cr18合金的燃气热腐蚀行为
 2
 C22哈氏合金换热器腐蚀原因及其防护措施
 2
 C-HRA-5奥氏体耐热钢晶粒尺寸分布对晶间腐蚀性能的影响
 2
 EPR法在评价304L不锈钢晶间腐蚀敏感性中的应用
 2
 HSn70-1船用冷凝管腐蚀穿孔失效分析
 2
 Incoloy825合金TIG和PAW焊接接头耐晶间腐蚀性能的对比
 2
 Inconel 800合金波纹管开裂的原因
 2
 S32101双相不锈钢焊接接头晶间腐蚀试验不合格原因
 2
 S32101双相不锈钢晶间腐蚀试验裂纹判定
 2
 S904L超级奥氏体不锈钢管钨极氩弧焊接头的力学性能与耐腐蚀性能
 2
 SUS301不锈钢生产过程中点状缺陷和裂纹的防范
 2
 TP304H奥氏体锅炉管高温运行显微特征
 2