搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
淬火温度对铜铝锰形状记忆合金两个内耗峰的影响
          
Effect of Quenching Temperature on the Two Internal Friction Peaks in a CuAlMn Shape Memory Alloy

摘    要
利用倒扭摆内耗仪研究了淬火温度对Cu-11.9Al-2.5Mn形状记忆合金升温过程中两个内耗峰的影响.结果表明:高温峰源于逆马氏体相变,低温峰则由孪晶畴的细化所引起.低温峰在淬火温度为700 ℃时有一最小值之后随淬火温度的升高而升高,因为在较高温度淬火可产生较大尺寸的孪晶,从而有利于孪晶畴界的移动.高温峰开始随温度升高而增大,在700 ℃淬火时达到最高值,淬火温度更高时反而降低,这与高温淬火引入的缺陷密度有关.
标    签 内耗   形状记忆合金   马氏体相变   internal friction   shape memory alloy   martensitic transformation  
 
Abstract
The effect of quenching temperature on the two internal friction peaks in a Cu-11.9Al-2.5Mn (wt%) shape memory alloy during heating was studied by using a low frequency inverted torsion pendulum internal friction instrument.It was demonstrated that the high-temperature peak aroise from the reversible martensitic transformation while the low-temperature peak from the refinement of twins.The low-temperature peak rose with increasing quench temperature because relatively high quench temperature produced relatively coarse twins whith were favorable for the sliding motion of the twins.The high-temperature peak reached its maximium at 700 ℃ and thereafter it declined as the quench temperature increased due to quench induced defect population.

中图分类号 O469 O77

 
  中国光学期刊网论文下载说明


所属栏目

基金项目

收稿日期 2005/8/20

修改稿日期 2006/5/22

网络出版日期

作者单位点击查看

备注孙蔚(1955-),女,安徽巢湖人,副教授,硕士.

引用该论文: SUN Wei,WANG Qiang,WANG Qing-zhou,HAN Fu-sheng. Effect of Quenching Temperature on the Two Internal Friction Peaks in a CuAlMn Shape Memory Alloy[J]. Materials for mechancial engineering, 2006, 30(9): 21~23
孙蔚,王强,王清周,韩福生. 淬火温度对铜铝锰形状记忆合金两个内耗峰的影响[J]. 机械工程材料, 2006, 30(9): 21~23


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】王景成,尤富强,祁金林,等.CuZnAl合金淬火和时效的正电子湮没研究——关于热弹性马氏体稳定化原因的讨论[J].功能材料,1999,30(3):265-269.
 
【2】李国旺,秦大成,李士琳,等.淬速对CuAlNi合金记忆性和伪弹性的影响[J].河北师范大学学报,1994,18(3):17-22.
 
【3】Wang Q Z,Han F S,Wang Q.Low frequency damping behavior of CuAlMn shape memory alloy[J].Phys Stat Sol,2004,201:2910-2914.
 
【4】Cahn R W.Twinned crystals[J].Adv Phys,1954,3:429-436.
 
【5】Liu Y,Xie Z L,Humbeeck J V,et al.Deformation of shape memory alloys associated with twinned domain re-configurations[J].Mater Sci Eng A,1999,273-275:679-684.
 
【6】Li Z P.A numerical study on the scale of laminated microstructure with surface energy[J].Mater Sci Eng A,2003,343:182-193.
 
【7】Mandel V S.Twin domains in nickel-oxide type crystals[J].J Crystal Growth,1997,174:346-353.
 
【8】Han F S,Zhu Z G,Gao J C.Damping behavior of foamed aluminum[J].Metall Mater Trans A,1999,30:771-776.
 
【9】冯端.金属物理学(第三卷)——金属力学性质[M].北京:科学出版社,1999.
 
【10】倪宏昕.高温形变淬火对奥氏体晶粒大小及马氏体形态的影响[J].彭城大学学报,1998,13(1):13-17.
 
【11】Arlt G.Review twinning in ferroelectric and ferroelastic geramics:stress relief[J].J Mater Sci,1990,22:2655-2665.
 
【12】Wang Y N,Sun W Y,Chen X H,et al.Internal friction associated with the domain walls and the second-order ferroelastic transition in LNPP[J].Phys Stat Sol,1987,102:279-284.
 
相关信息
   标题 相关频次
 含宏观孔通孔多孔铝的低频阻尼行为
 4
 宏观石墨颗粒增强铜基形状记忆合金复合材料的阻尼行为
 4
 油淬Ni64Al36合金的逆马氏体相变
 4
 不同温度淬火后Co39Ni34Al27形状记忆合金的组织与性能
 3
 20MnCr5钢齿轮表面渗碳层的显微组织
 2
 Ni40.5Co32.5Al27合金冷轧带材阻尼性能与相变和组织的关系
 2
 Ni-Mn-In基磁制冷合金的研究进展
 2
 Ni-Ti-Nb宽滞后形状记忆合金焊接环拉伸断裂分析
 2
 NiTi基体上沉积铁电陶瓷PZT复合材料的振动响应特性
 2
 SiC颗粒增强镁-锌-锆基复合材料的阻尼性能
 2
 不同成形厚度对奥氏体不锈钢封头组织和性能的影响
 2
 不同压力条件下熔融硅除磷的效果及机理
 2
 单扫描示波极谱法测定食品中禁用色素苏丹红Ⅰ
 2
 单轴拉伸下中锰钢组织演变和力学行为的数值模拟
 2
 低密度TiB2/铝基复合材料的显微组织与内耗性能
 2
 低碳铝镇静软质镀锡钢板在生产过程中织构和固溶碳含量变化
 2
 顶空固相微萃取-气相色谱-质谱法测定软木塞中愈创木酚的含量
 2
 飞机常用镀镉钢在机场道面除冰液中的腐蚀行为
 2
 风机叶片结构的Lamb波损伤成像监测
 2
 高干涉量压合衬套强化铝合金孔结构的疲劳性能
 2
 高温形状记忆合金的研究进展
 2
 高效液相色谱-质谱法及模式识别法用于鉴别普洱生茶与熟茶
 2
 工艺参数对超低碳烘烤硬化钢固溶碳含量和烘烤硬化性能的影响
 2
 固溶碳原子对IF钢Snoek内耗峰的影响
 2
 固溶温度对铜-铝-锰形状记忆合金冷加工性能的影响
 2
 宏观孔对锌铝共析合金阻尼行为的影响
 2
 宏观石墨颗粒对工业纯铝阻尼性能的影响
 2
 宏观石墨颗粒增强工业纯铝基复合材料的阻尼性能
 2
 机械合金化法制备Mg55Ni35Si10非晶合金粉体
 2
 基体组织和加工过程对不锈钢餐、厨具铬离子析出量的影响
 2