搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
改进型的磁流变液剪切屈服强度测试仪
          
An Improved Instrument for Measuring the Yield Shear Strength of MRF

摘    要
根据两个相对运动的平行圆盘间的流体简单剪切流状态的原理,设计了一种改进型的旋转圆盘式磁流变液剪切屈服强度测试仪.测试仪采用可细分式步进电机驱动测试圆盘,通过扭矩传感器测量上下圆盘间的磁流变液发生流变后所产生的扭矩,从而计算出磁流变液的剪切屈服强度.对剪切圆盘机构和磁路进行了优化设计分析,将剪切圆盘置于电磁线圈内部的中间位置,将测试圆盘所在区域的磁场强度不均匀性降至1%,从而可大大降低测量误差.
标    签 磁流变液   剪切屈服强度   测试仪   magnetorheological fluid   yield shear strength   testing instrument  
 
Abstract
An improved instrument used for measuring the yield shear strength of magnetorheological fluid (MRF) was designed,based on the principle of simple shearing stream between two relative moving parallel circle plates.A micro-stepping motor driver was used in this instrument to control the rotating of the measuring circle plates.The torquemoment of MRF between the two circle plates was measured by sensor.And then the yield shear strength was calculated by computer.The design of shear circle plates and the magnetic circuit were optimized.The shear circle plates were located in the middle of the electromagnetism coil.The uniformity of the magnetic field in circle plates was 1%.So the measurement error is reduced greatly.

中图分类号 TB126

 
  中国光学期刊网论文下载说明


所属栏目

基金项目

收稿日期 2006/7/18

修改稿日期 2006/10/11

网络出版日期

作者单位点击查看

备注朱航(1969-),男,浙江宁波人,硕士.

引用该论文: ZHU Hang,LIU Shi-jun,ZHANG You-lin,QI Xing-hong,GAO Lan-lan. An Improved Instrument for Measuring the Yield Shear Strength of MRF[J]. Materials for mechancial engineering, 2007, 31(6): 34~37
朱航,刘士军,张佑林,祁型虹,高岚岚. 改进型的磁流变液剪切屈服强度测试仪[J]. 机械工程材料, 2007, 31(6): 34~37


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】Rabinow J.The magnetic fluid clutch[J].AIEE Transaction,1948,67:1308-1315.
 
【2】彭金松,萧蕴诗,苏永清,等.磁流变液的流变特性及其应用前景[J].液压与气动,2003(8):27-29.
 
【3】王琪民,徐国梁,金建峰.磁流变液的流变性能及其工程应用[J].中国机械工程,2002,13(3):267-270.
 
【4】Jolly M R,Bender J W,Carlson J D.Properties and applications of commercial magnetorheological fluids[J].Journal of Intelligent Material Systems and Structures,1999,10:5-13.
 
【5】戴一帆,尤伟伟,彭小强.磁流变液流变性能测试系统的研究[J].航空精密制造技术,2005,41(4):17-19.
 
【6】廖昌荣,陈爱军,张红辉,等.磁流变液的流变学特性检测方法与仪器[J].仪器仪表学报,2004,25(4):84-87.
 
【7】金昀,周刚毅.两种磁流变液测试系统的比较研究[J].实验力学,1999,14(3):288-293.
 
【8】Phillips R W.Engineering applications of fluids with variable yield stress[D].Berkeley,California:University of California,1969.
 
【9】Lemire E,Bossis G.Yield stress and wall effects in magnetic colloidal suspensions[J].Phys D:Appl Phys,1991,24:1473-1477.
 
【10】周刚毅,唐新鲁,张培强,等.磁流变液流变特性测试系统.中国,CN 1388366A[P].2003.
 
【11】佘守宪,张思炯.Helmholtz线圈、直螺线管及圆电流磁场均匀性分析的简单公式[J].大学物理,1999,18(8):1-6.
 
相关信息
   标题 相关频次
 钛酸酯偶联剂含量对磁流变液性能的影响
 3
 磁场作用下羰基铁粉磁流变液的剪切特性
 2
 磁流变液沉降稳定性的研究进展
 2
 明胶-氧化铁磁流变液的制备及性能
 2
 硅油基磁流变液的制备及其特性
 1
 基于分数阶微积分的磁流变液粘弹性模拟
 1
 基于声波的管道泄漏点定位检测仪的开发
 1
 利用氧化铁皮制备还原铁粉磁流变液
 1
 湿拉拉拔速度对钢帘线用碳质量分数为0.92%镀铜钢丝性能的影响
 1
 稳定型硅油基磁流变液的制备及性能
 1
 无线自动爬行漏磁检测仪的开发研制
 1
 铸铁设备无损检测技术进展
 1