搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
银对Bi1.6Pb0.4Sr2Ca2Cu3Ox超导材料摩擦学性能的影响
          
Effect of Ag on Tribological Properties of Bi1.6Pb0.4Sr2Ca2Cu3Ox Superconducting Materials

摘    要
通过高温固相反应法制备了不同银含量的Ag/Bi1.6Pb0.4Sr2Ca2Cu3Ox超导材料,用XRD和SEM分析了其物相组成及显微结构;用销-盘式摩擦试验机研究了该材料从低温到常温的摩擦学性能.结果表明:Ag/Bi1.6Pb0.4Sr2Ca2Cu3Ox材料由超导相和银相组成;温度从室温降低到超导转变温度以下时,其摩擦因数明显降低,在非超导态时摩擦因数为0.4,达到超导转变温度时摩擦因数为0.2;加入银后其摩擦因数随载荷和滑动速度的提高而增大;银含量对其摩擦因数的影响规律不明显;加入银后可提高其减摩耐磨性能.
标    签 Ag/Bi1.6Pb0.4Sr2Ca2Cu3Ox   摩擦学性能   超导转变温度   Ag/Bi1.6Pb0.4Sr2Ca2Cu3Ox   tribological property   superconductig transition temperature  
 
Abstract
Superconducting composites Ag/Bi1.6Pb0.4Sr2Ca2Cu3Ox with different contents of silver were successfully synthesized by high-temperature solid-state reaction method.The microstructure and phase composition of the as-synthesized samples were characterized by XRD and SEM.The tribological properties from ultra-low temperature to room temperature of the materials were studied by pin-on-disk friction testing.The results indicate that Ag/Bi1.6Pb0.4Sr2Ca2Cu3Ox materials were composed of superconductor phase and Ag phase.The friction coefficient of the samples decreased obviously when the temperature was lowered to less than the superconducting transition temperature.The friction coefficient was 0.4 in non-superconducting state.At superconducting transition temperature,the friction coefficient was 0.2.The friction coefficient of the material with addition of Ag increased with the increase of load and sliding speed.The influence law of Ag content on the friction coefficient was not significant.The properties of antifriction and wear resistance were improved after Ag addition.

中图分类号 TB33

 
  中国光学期刊网论文下载说明


所属栏目 材料性能及其应用

基金项目 国家自然科学基金资助项目(S0372026)

收稿日期 2008/12/30

修改稿日期 2009/9/21

网络出版日期

作者单位点击查看

备注彭义(1984-),男,湖南长沙人,硕士研究生.

引用该论文: PENG Yi,LI Chang-sheng,WANG Min-lu,DING Jian,ZHU Bing-ying. Effect of Ag on Tribological Properties of Bi1.6Pb0.4Sr2Ca2Cu3Ox Superconducting Materials[J]. Materials for mechancial engineering, 2010, 34(1): 80~83
彭义,李长生,王旻璐,丁建,朱秉莹. 银对Bi1.6Pb0.4Sr2Ca2Cu3Ox超导材料摩擦学性能的影响[J]. 机械工程材料, 2010, 34(1): 80~83


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】JOO J,JUNG S B,NAH W,et al.Effects of silver additions on the mechanical properties and resistance to thermal shock of YBa2Cu3O7-δ superconductors [ J ].Cryogenics,1999,39:107-113.
 
【2】WIDOM A,KRIM J.Q factors of quartz oscillator modes as a probe of submonolayer-film dynamics[J].Physical Review B,1986,34:1403-1403.
 
【3】KRIM J,WIDOM A.Damping of a crystal oscillator by an adsorbed monolayer and its relation to interfacial viscosity[J].Physical Review B,1988,38:12184-12189.
 
【4】KRIM J.Atomic-scale origins of friction[J].Langmuir,1996,12:4564-4566.
 
【5】MASON B L,WINDER S M,KRIM J.On the current status of quartz crystal microbalance studies of superconductivity-dependent sliding friction[J].Tribology Letters,2001,10(1/2):59-65.
 
【6】TORRES E,GONCALVES S.Nanoscale sliding friction versus commensuration tatio:Molecular dynamics simulations[J].Physical Review B,2006,73(3):1-8.
 
【7】DING Qiao-dang,LI Chang-sheng,DONG Li-rong,et al.Preparation and properties of YBa2Cu3O7-δ/Ag self-lubricating composites[J].Wear,2008,265(7/8):1136-1141.
 
【8】姜春华,李长生.镍-铬基自润滑复合材料的制备及性能[J].机械工程材料,2007,31(4):48-51.
 
【9】董丽荣,李长生.超导体YBa2Cu3O7-δ 的摩擦学特性研究[J].摩擦学学报,2008,28(4):245-350.
 
【10】董丽荣,李长生.超导Pb/YBa2Cu3O7-δ 复合氧化物摩擦磨损性能[J].复合材料学报,2008,25(4):143-148.
 
【11】BEN A F,CHIRGUI A M.Synthesis,microstructural evolution and the role of substantial addition of PbO during the final processing of (Bi,Pb)-2223 superconductors[J].Physica C,2001,356(1/2):83-96.
 
【12】MARINKOVIC B A,JARDIM P M.Characterization and phase transitions of (Bi,Pb)2Sr2Ca2Cu3Ox-Ag composite powder obtained by spray pyrolysis[J].Materials Chemistry and Physics,2005,94(2/3):233-240.
 
【13】GUL I H,MIN F A.Effect of Ag2CO3 addition on the morphology and physical properties of Bi-based (2223) high-Tc superconductors[J].Physica C,2006,449(2):139-147.
 
相关信息
   标题 相关频次
 固相烧结合成WSe2纳米棒的微观形貌及摩擦学性能
 4
 球磨-固相烧结合成WS2六方纳米片及其摩擦学性能
 4
 水热法合成花状MoS2纳米粉及其摩擦学性能
 4
 MoSe2纳米片的制备及其摩擦性能
 3
 钛铝系金属间化合物薄膜的制备和摩擦性能
 3
 (MgCoNiCuZn)O高熵氧化物陶瓷涂层的制备及性能
 2
 20CrNiMo钢表面磁控溅射制备TiN/ZrN多层薄膜的形貌及摩擦学性能
 2
 Ag/YBa2Cu3O7-δ自润滑复合材料的力学及摩擦性能
 2
 Fe-1.6%Si无取向硅钢的热变形与相变规律
 2
 MoS2/Ni复合膜的微结构与摩擦学性能
 2
 MPU/UHMWPE共混体系的摩擦学性能及拉伸性能
 2
 NbSe2纳米颗粒的合成及减摩性能
 2
 TiAl基合金成分对其高温摩擦学性能的影响
 2
 苯并三氮唑羧酸衍生物和磷酸三丁酯的摩擦学协同性能
 2
 表面织构化对摩擦学性能影响的研究进展
 2
 不同含量Ti3AlC2/Cu复合材料在不同条件下的摩擦学性能
 2
 不同交联密度下硫化丁腈橡胶摩擦特性的分子动力学模拟
 2
 磁控溅射MoS2/Ni复合膜的制备及其摩擦性能
 2
 海洋环境中运动副材料摩擦学性能的研究进展
 2
 加入无磷三嗪衍生物添加剂菜籽油的摩擦学性能
 2
 金刚石粒子增强锌铝基耐蚀涂层的制备及其性能
 2
 聚酯纤维布增强环氧树脂基复合材料的拉伸和摩擦学性能
 2
 聚酯纤维布增强聚氨酯树脂基复合材料的摩擦学性能
 2
 类金刚石薄膜摩擦学性能影响因素及改善措施的研究进展
 2
 磷酸锰转化涂层和硫化亚铁涂层的摩擦学性能对比
 2
 模板法合成CuS超长微米线及其表征
 2
 镍-铬基自润滑复合材料的制备及性能
 2
 全自动板材和圆棒力学试样的加工及检验技术
 2
 实验室薄板坯连铸连轧Fe-3%Si热轧钢板的织构
 2
 实验室薄板坯连铸连轧电工钢板的组织与性能
 2