Auto Ultrasonic Testing of the Micro Defects Close to the Surface in the T-Shaped Laser Welding Joint
摘 要
给出了超声波自动检测过程中影响C扫描图像成像质量的各种参数,如探头的种类、水程、扫查灵敏度和闸门,并对设计和加工的模拟试件进行了超声水浸检测,获得焊缝中的模拟缺陷图像。与X射线照相图片对比结果表明,应用此方案检测T型钛合金激光焊缝时,可以发现在焊缝表面粗糙度较小的试件表面以下1.0~2.5 mm深处、直径>0.3 mm的缺陷。
Abstract
The probability of pores produced in the laser welds are high when joining titanic alloy by Laser welding. The joint needs to be nondestructive tested for using in the aero fields. The parameters affecting C-scan image were given during the automatic ultrasonic inspection, such as the probe, the water path, amplitude, and the gate. The image of simulated pores in the welds was gained through testing the simulated sample and comparing with the radiograph. The experimental results showed that the defect, which was below surface with small roughness 1.0~2.5 mm depth and the diameter of which was bigger than 0.3 mm, could be found, when this testing process was used to detect the T-shape Ti alloy laser welding joint.
中图分类号 TG115.28
所属栏目 科研成果与学术交流
基金项目
收稿日期 2006/4/3
修改稿日期
网络出版日期
作者单位点击查看
备注郭立伟(1971-),女,博士研究生,副教授,研究方向为焊接无损检测。
引用该论文: GUO Li-wei,GANG Tie. Auto Ultrasonic Testing of the Micro Defects Close to the Surface in the T-Shaped Laser Welding Joint[J]. Nondestructive Testing, 2007, 29(12): 698~700
郭立伟,刚 铁. T型激光焊接接头近表面微小缺陷的自动超声波检测[J]. 无损检测, 2007, 29(12): 698~700
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】周振丰,张文钺.焊接冶金与金属焊接性[M].北京:机械工业出版社,1987:435-445.
【2】郭 鹏,杨家林.TC4钛合金精密焊接工艺研究[J].机械,2001,(4):35-36.
【3】张 旭.钛合金材料焊接工艺和质量控制的探讨[J].化工设备与管道,2002,(4):59-62.
【2】郭 鹏,杨家林.TC4钛合金精密焊接工艺研究[J].机械,2001,(4):35-36.
【3】张 旭.钛合金材料焊接工艺和质量控制的探讨[J].化工设备与管道,2002,(4):59-62.
相关信息