ffect of Specimen Size on the Plastic Strain Ratio r of steel plate
摘 要
选用三种尺寸的拉伸试样测试塑性应变比(r值)。通过试验和数据分析,得出当试验标距接近试样平行长度时,r值将下降。其原因是当标距接近试样平行长度时,试样标距内的应变是不均匀的。
Abstract
The plastic strain ratio (r value)was tested by the tensile samples of three kinds of size. The experiment results showed that the r value descended when the gauge length was near to the parallel length. Its reason was that the strain in the tensile sample gauge length was non-uniform at that time.
中图分类号 TB302.3
所属栏目 试验技术与方法
基金项目
收稿日期 2007/11/26
修改稿日期
网络出版日期
作者单位点击查看
备注徐惟诚(1963-),男,工程师。
引用该论文: XU Wei-cheng,SHI Qiang-zhong,LI He-ping,SU Da-xiong. ffect of Specimen Size on the Plastic Strain Ratio r of steel plate[J]. Physical Testing and Chemical Analysis part A:Physical Testing, 2009, 45(2): 94~96
徐惟诚,施强忠,李和平,苏大雄. 试样尺寸对钢板塑性应变比r的影响[J]. 理化检验-物理分册, 2009, 45(2): 94~96
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】苏大雄. 试样类型对金属薄板塑性应变比(r值)测量影响原因分析[J]. 理化检验-物理分册,2006,42(3):113-115.
【2】GB/T 5027-1999金属薄板和薄带塑性应变比(r值)试验方法[S].
【3】JIS Z 2201-1998The pieces for tensile test for metallic materials[S].
【4】JIS Z 2254-1996Method of determining the plastic strain ratio for metallic sheet and strip[S].
【5】JFS T 2001-1996薄钢板及钢带塑性应变比试验方法[S].
【2】GB/T 5027-1999金属薄板和薄带塑性应变比(r值)试验方法[S].
【3】JIS Z 2201-1998The pieces for tensile test for metallic materials[S].
【4】JIS Z 2254-1996Method of determining the plastic strain ratio for metallic sheet and strip[S].
【5】JFS T 2001-1996薄钢板及钢带塑性应变比试验方法[S].
相关信息