Forging Internal Crack Analysis of Large Thick-walled Tube
摘 要
采用化学成分分析、硬度测定、力学性能测试、金相检验及综合分析等方法对内壁表面出现裂纹的大型厚壁管坯进行了分析。结果表明:由于锻造加热时间不足和选用型砧方式不当引起大型管坯内壁产生放射状裂纹。
Abstract
On the inner wall surface through the cracks of large thick-walled tube for chemical composition analysis,hardness,mechanical testing,metallography inspection and analysis. The results showed that,inside large tube radial cracks due to the lack of time and forging heating-anvil approach improper use caused by forging the split.
中图分类号 TG142.41
所属栏目 质量控制与失效分析
基金项目
收稿日期 2008/2/18
修改稿日期
网络出版日期
作者单位点击查看
备注姚淑萍(1962-),女,工程师。
引用该论文: YAO Shu-ping,DONG Xia,LI Xiao-ling,ZONG Guo-qing,CHEN Yu-xuan. Forging Internal Crack Analysis of Large Thick-walled Tube[J]. Physical Testing and Chemical Analysis part A:Physical Testing, 2009, 45(2): 111~113
姚淑萍,董霞,李晓玲,宗国庆,陈宇轩. 大型厚壁管坯锻造内裂分析[J]. 理化检验-物理分册, 2009, 45(2): 111~113
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】陈南平.机械零件失效分析[M]. 北京:清华大学出版社,1988.
【2】马 祥,白德忠.大型锻件制造工艺学[M]. 包头:内蒙古第二机械制造厂职工工学院,1984.
【2】马 祥,白德忠.大型锻件制造工艺学[M]. 包头:内蒙古第二机械制造厂职工工学院,1984.
相关信息