Application of Pole Figure on Crystal Determination and Orientation Analysis
摘 要
采用极图法并结合金相法分别对定向凝固生长的FeGa和CuAlNi合金进行了晶体判定和取向分析。结果表明:FeGa合金为多晶体,表层存在六个晶粒,根据极点分布,确定该合金为四方晶系;CuAlNi为单晶体,确定欧拉角为φ1=150°,φ=22°,φ2=0°,并据此旋转定向,重新切割后测量极图,晶体得到了很好的定向;极图法判定结果与金相检验结果一致。
Abstract
Pole figures and microstructure of FeGa and CuAlNi alloys were measured respectively. The results show that FeGa alloy was a multi-crystallite,there were six crystallite grain in the surface layer,and the structure was tetragonal by analyzing the pole plots distribution. CuAlNi alloy was single crystal,the Euler angles calculated from pole figures were φ1=150°,φ=22°,φ2=0°and the pole figure showed that the crystal got the right crystal orientation after orientation adjustment. Results gained from pole figure method and microstructure analysis were identical.
中图分类号 TG115.22+2
所属栏目 试验技术与方法
基金项目
收稿日期 2009/3/20
修改稿日期
网络出版日期
作者单位点击查看
备注王书明(1981-),男,工程师,硕士。
引用该论文: WANG Shu-ming,LIU Jing-hua,WANG Chao-qun,LIU Shu-feng. Application of Pole Figure on Crystal Determination and Orientation Analysis[J]. Physical Testing and Chemical Analysis part A:Physical Testing, 2009, 45(12): 751~753
王书明,刘敬华,王超群,刘淑凤. 极图在晶体判定和取向分析中的应用[J]. 理化检验-物理分册, 2009, 45(12): 751~753
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】姚鸿年. 金相实验技术的现状及其发展[J]. 理化检验-物理分册,1994,30(5):7-10.
【2】雷新颖,郭让民,李中奎,等. 钼单晶的判定及其偏离角的测试[J]. 理化检验-物理分册,2003,39(6):295-297.
【3】郭宇航,金云学,张丽华,等. 金属电子背散射衍射试样的制备技术[J]. 理化检验-物理分册,2007,43(8):993-304.
【4】李树棠. 晶体X射线衍射学基础[M]. 北京: 冶金工业出版社,1996:191-195.
【5】BUNGE H J. Texture Analysis in Materials Science[M].London:Butterworths,1982:150.
【6】潘金生. 单晶体LAUE照相和电子衍射谱的分析方法[J]. 金属学报,1982,6: 703-712.
【2】雷新颖,郭让民,李中奎,等. 钼单晶的判定及其偏离角的测试[J]. 理化检验-物理分册,2003,39(6):295-297.
【3】郭宇航,金云学,张丽华,等. 金属电子背散射衍射试样的制备技术[J]. 理化检验-物理分册,2007,43(8):993-304.
【4】李树棠. 晶体X射线衍射学基础[M]. 北京: 冶金工业出版社,1996:191-195.
【5】BUNGE H J. Texture Analysis in Materials Science[M].London:Butterworths,1982:150.
【6】潘金生. 单晶体LAUE照相和电子衍射谱的分析方法[J]. 金属学报,1982,6: 703-712.
相关信息