搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
Inconel 740H合金在纯水蒸气环境中的高温氧化行为
          
High Temperature Oxidation Behavior of Inconel Alloy 740H in Pure Steam

摘    要
通过高温氧化试验研究了Inconel 740H合金在750 ℃的动态纯水蒸气环境中的氧化行为。结果表明: Inconel 740H合金的氧化增重近似遵循抛物线规律, 随氧化时间的延长氧化产物粗大; 氧化膜形貌与在干燥空气中氧化的明显不同, 但未发现明显的氧化膜开裂和剥落现象; 合金氧化100 h后形成连续的Cr2O3氧化膜, 氧化膜厚度随着氧化时间的增加而增大; 氧化1 000 h后形成的氧化膜主要由Cr2O3和少量的(Mn, Ni)Cr2O4尖晶石组成, 靠近氧化膜的合金内部出现明显的贫铬区, 并伴生少量的Al2O3和TiO2内氧化产物。
标    签 Inconel 740H合金   纯水蒸气   高温氧化   超超临界机组   Inconel alloy 740H   pure steam   oxidation   ultra-supercritical power station  
 
Abstract
The oxidation behavior of Inconel alloy 740H in dynamic pure steam at 750 ℃ was studied with high temperature oxidation test. The results show that the mass gain of Inconel alloy 740H during oxidation followed a parabolic law approximately. The oxide products grew coarse with the increase of oxidation time. The scale morphology was significantly different from those after oxidation in dry air. But non obvious cracks and spallation were observed. After oxidation for 100 h, the protective Cr2O3 film formed on the surface. The thickness of oxide film increased with time increasing. After oxidation for 1 000 h, the oxide film was composed of Cr2O3 and a small amount of (Mn, Ni)Cr2O4 spinel. Beneath the oxide scale, chromium depletion region was found and a small amount of inner oxides identified as Al2O3 and TiO2 were observed.

中图分类号 TG132.3   DOI 10.11973/jxgccl201510009

 
  中国光学期刊网论文下载说明


所属栏目 试验研究

基金项目 国家自然科学基金青年基金资助项目(51301130; 51301131)

收稿日期 2014/8/18

修改稿日期 2015/7/1

网络出版日期

作者单位点击查看

备注鲁金涛(1984-), 男, 河北唐山人, 高级工程师。

引用该论文: LU Jin-tao,YANG Zhen,XU Song-qian,ZHAO Hai-ping,ZHAO Xin-bao,GU Yue-feng. High Temperature Oxidation Behavior of Inconel Alloy 740H in Pure Steam[J]. Materials for mechancial engineering, 2015, 39(10): 37~41
鲁金涛,杨珍,徐松乾,赵海平,赵新宝,谷月峰. Inconel 740H合金在纯水蒸气环境中的高温氧化行为[J]. 机械工程材料, 2015, 39(10): 37~41


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】纪世东, 周荣灿, 王生鹏, 等.700 ℃等级先进超超临界发电技术研发现状及国产化建议[J].热力发电, 2011, 40(7): 86-88.
 
【2】PATEL S J, BAKER B A, GOLLIHUE R D. Nickel base superalloys for next generation coal fired A-USC power plants[J]. Procedia Engineering, 2013, 55: 246-252.
 
【3】赵双群, 董建新, 张麦仓, 等.新一代超级超临界锅炉过热器用管材Inconel 740[J].钢铁研究学报, 2003, 15(7): 160-164.
 
【4】EVANS N D, MAZIASZ P J, SWINDEMAN R W. Microstructure and phase stability in INCONEL alloy 740 during creep[J]. Scripta Materialia, 2004, 51(6): 503-507.
 
【5】SHINGLEDECKER J P, PHARR G M.The role of eta phase formation on the creep strength and ductility of INCONEL Alloy 740 at 1 023 K (750 ℃)[J]. Metallurgical and Materials Transactions, 2012, 43: 1902-1910.
 
【6】CHONG Yan, LIU Zheng-dong, GODFREY A, et al. Microstructure evolution and mechanical properties of Inconel 740H during aging at 750 °C[J].Materials Science & Engineering A, 2014, 589: 153-164.
 
【7】ZHAO Shuang-qun, XIE Xi-shan, SMITH G D, et al. Research and Improvement on structure stability and corrosion resistance of nickel-base superalloy INCONEL alloy 740[J]. Materials and Design, 2006, 27(10): 1120-1127.
 
【8】NATESAN K, PARK J H. Fireside and steam side corrosion of alloys for USC plants[J].International Journal of Hydrogen Energy, 2007, 32(16): 3689-3697.
 
【9】COWEN C J, DANIELSON P E, JABLONSKI P D. The microstructural evolution of Inconel alloy 740 during solution treatment, aging, and exposure at 760 ℃[J].Journal of Materials Engineering and Performance, 2011, 20(6): 1078-1083.
 
【10】TAKEDA Y, KANAYA M, YAMAMOTO S, et al. Oxidation and cracking behavior of Nickel base superalloys under bending stress in advanced steam condition beyond 700 ℃[M]//CENK F, CHI Y, WANG F.Challenges of Power Engineering and Environment.[S.l.]: Springer Berlin Heidelberg, 2007: 1031-1036.
 
【11】BERTHOD P, ARANDA L, MATHIEU S, et al.Influence of water vapour on the rate of oxidation of a Ni-25wt.% Cr alloy at high temperature[J]. Oxidation of Metals, 2013, 79(5/6): 517-527.
 
【12】GUILLOU S, CABET C, DESGRANGES C. Influence of hydrogen and water vapour on the kinetics of chromium oxide growth at high temperature[J]. Oxidation of Metals, 2011, 76: 193-214.
 
【13】ASTEMAN H, SVENSSON J E, NORELL M, et al.Influence of water vapour and flow rate on the high-temperature oxidation of 304L: effect of chromium oxide hydroxide evaporation[J]. Oxidation of Metals, 2000, 54(1/2): 11-26.
 
【14】ESSUMAN E, MEIER G H, ZUREK J, et al. Protective and non-protective scale formation of NiCr alloys in water vapour containing high- and low-pO2 gases[J]. Corrosion Science, 2008, 50(6): 1753-1760.
 
【15】PUJILAKSONO B, JONSSON T, HALVARSSON M, et al. Paralinear oxidation of chromium in O2+H2O environment at 600-700 ℃[J]. Oxidation of Metals, 2008, 70(3/4): 163-188.
 
【16】YAMAUCHI A, SUZUKI Y, SAKAGUCHI N, et al. Microstructure and analysis of oxide scales formed on Cr-Si-Ni compacts in air and H2O-containing atmosphere[J]. Corrosion Science, 2010, 52(6): 2098-2103.
 
【17】赵双群, 谢锡善, 董建新. Inconel 740 合金在空气和含有水蒸气的空气中的氧化研究[J]. 动力工程学报, 2011, 31(10): 797-802.
 
【18】ASTEMAN H, SVENSSON J E, JOHANSSON L G. Oxidation of 310 steel in H2O/O2 mixtures at 600°C: the effect of water vapour enhanced chromium evapouration[J].Corrosion Science, 2002, 44(11): 2635-2649.
 
【19】CASTANEDA S I, PEREZ F J. Microstructure and volatile species determination of ferritic/martensitic FB2 steel in contact with Ar+40% H2O at high temperatures[J]. Oxidation of Metals, 2013, 79(1/2): 147-166.
 
【20】叶长江, 沈嘉年, 李铁藩. 合金元素硅和铈对镍铬合金高温氧化行为的协同作用[J]. 中国腐蚀与防护学报, 1993, 13(3): 229- 235.
 
【21】ISHITSUKA T, INOUE Y, OGAWA H.Effect of silicon on the steam oxidation resistance of a 9% Cr heat resistant steel[J]. Oxidation of Metals, 2004, 61(1/2): 125-141.
 
相关信息
   标题 相关频次
 700℃先进超超临界机组末级过热器用新型镍铁基高温合金的组织与性能
 6
 Incoloy800H合金在高温纯水蒸气中的氧化行为
 3
 铝化物涂层改性Super304H钢在模拟锅炉煤灰/气环境中的腐蚀行为
 3
 烟气脱硝用尿素水解装置关键部件用候选材料的腐蚀行为
 3
 HJ741-2015试验条件的优化及在土壤中27种挥发性有机物检测中的应用
 2
 K52合金纳米晶涂层的1000℃氧化行为
 2
 基于外管进样增强信号技术的氢化物发生-原子荧光光谱法测定食品中铅和镉的含量
 2
 氢化物发生-电感耦合等离子体原子发射光谱分析技术的研究进展
 2
 1 GW超超临界直流炉的自动控制策略与调试
 1
 1000MW超超临界机组C12A堵板阀裂纹成因分析
 1
 304、316不锈钢和Inconel 617镍基合金在硝酸熔盐中的腐蚀行为
 1
 7A04铝合金产品表面起泡原因分析
 1
 800 ℃长期氧化过程中含铝奥氏体耐热钢中第二相的演化规律
 1
 Al0.5FeCoCrNi(Si0.2, Ti0.5)高熵合金的高温氧化性能
 1
 DZ4合金渗铝-硅涂层1100℃氧化时的元素扩散规律
 1
 Fe-Al/TiC激光熔覆层的高温摩擦磨损和氧化性能
 1
 GCr15SiMn钢轴承套圈缺陷成因分析
 1
 Nb521表面改性Si-Cr-Ti涂层的高温氧化行为
 1
 Sanicro 25耐热钢的研究现状及应用前景
 1
 Super304H超超临界锅炉过热器管长期服役后的显微组织及力学性能
 1
 T91钢和TP304钢对含氯盐水蒸气的抗氧化性能
 1
 Ti3SiC2/SiC复合材料高温氧化行为研究
 1
 TiAl合金表面NiCrAlY涂层的抗高温氧化性能
 1
 TiAl合金表面NiCrAlY涂层的抗高温氧化性能
 1
 VAMTOP套管接箍镀铜层变色原因分析
 1
 Y2O3含量对Ni-20Cr-5Al合金高温抗氧化性能的影响
 1
 γ-TiAl合金表面双层辉光等离子铬钨共渗层的高温氧化行为
 1
 表面堆焊制备侧压机模块的性能及应用
 1
 不同碱度和温度条件下硫化氢溶液的稳定性研究
 1
 不锈钢炉管运行近10 000 h后的氧化物检测及分析
 1