Application of LLT Probe in Testing of Welds of Thick Wall and Narrow Gap
摘 要
探讨了LLT技术的基本原理, 及其在厚壁窄间隙焊缝检测中的实际应用。同时验证了该技术在实际工件上的检测能力。研究结果表明, LLT技术对垂直于检测面的面积性缺陷有着非常高的检测灵敏度, 虽然该技术不能对缺陷进行定量分析, 但能够比较准确的对缺陷进行定性, 因此, LLT技术可以作为常规检测方法的有效补充。
Abstract
The principle of LLT method, and practical inspection experience were introduced. Result showed that LLT method could detect defects perpendicular to the test surface with high sensitivity, but could not measure its sizing. By the combination of the Tip method and LLT method, the characteristics and sizes of defects could be analyzed.
中图分类号 TG115.28
所属栏目 试验研究
基金项目
收稿日期 2009/4/11
修改稿日期
网络出版日期
作者单位点击查看
备注汪明辉(1982-), 男, 本科, 工程师, 从事超声检测及超声技术研究工作。
引用该论文: WANG Ming-Hui,YAN Xiao-Bo,PANG Tian-Guo. Application of LLT Probe in Testing of Welds of Thick Wall and Narrow Gap[J]. Nondestructive Testing, 2010, 32(3): 175~178
汪明辉,严小波,庞天国. LLT探头在厚壁窄间隙焊缝检测中的应用[J]. 无损检测, 2010, 32(3): 175~178
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】Komura Ichiro. Nondestructive inspection technologies for the inservice inspection of NPP[J]. Journal of the Japan Institute of Energy, 2004, 83(7): 485-492.
相关信息