Modification of Method for Rapid Determination of Modulus of Water Glass
摘 要
报道了水玻璃模数测定方法的改进,有以下要点:① 加入氟化钠过饱和溶液,以保证与二氧化硅充分完全反应;② 基本固定取样量,以免取样过多或过少所造成误差;③ 随试样的分析全过程,作空白试验,以补偿由氟化钠所引起的碱度;④ 用精密pH试纸或pH计检测滴定终点.以上改进提高了方法的分析速度和精密度.
Abstract
Modifications of the conventional method for the determination of modulus of water glass were described in this paper. The main points are as follows: ① A supersaturated solution of sodium fluoride was used to ensure its complete reaction with SiO2;② Definite amount of sample was taken to avoid error arisen from variations of sample mass;③ A blank test was taken through the whole process of determination to compensate the alkalinity of sodium fluoride;and ④ End-point of titration was recognized by checking with precise pH-paper or determined by pH-meter. More rapid and precise determinations were achieved by these modifications.
中图分类号 O65
所属栏目 工作简报
基金项目
收稿日期 2006/9/6
修改稿日期
网络出版日期
作者单位点击查看
备注汪华方(1979-),男,湖北汉川人,主要研究方向为先进制造技术.
引用该论文: WANG Hua-fang,FAN Zi-tian. Modification of Method for Rapid Determination of Modulus of Water Glass[J]. Physical Testing and Chemical Analysis part B:Chemical Analysis, 2008, 44(1): 47~49
汪华方,樊自田. 水玻璃模数快速测定方法的改进[J]. 理化检验-化学分册, 2008, 44(1): 47~49
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】朱纯熙,卢晨,季敦生.水玻璃砂基础理论[M].上海:上海交通大学出版社,2000:8.
【2】樊自田,董选普,陆浔.水玻璃砂工艺原理及应用技术[M].北京:机械工业出版社,2004:3.
【3】华东化工学院分析化学教研组.分析化学[M].北京:人民教育出版社,1983:4.
【4】GB/T 4209-1996工业硅酸钠[S].
【5】秦克刚,李淑珍.水玻璃模数的快速测定[J].理化检验-化学分册,2000,36(10):472-473.
【6】关伟宏.水玻璃模数的快速测定实验研究[J].化学工程师,2002,93(6):54-55.
【2】樊自田,董选普,陆浔.水玻璃砂工艺原理及应用技术[M].北京:机械工业出版社,2004:3.
【3】华东化工学院分析化学教研组.分析化学[M].北京:人民教育出版社,1983:4.
【4】GB/T 4209-1996工业硅酸钠[S].
【5】秦克刚,李淑珍.水玻璃模数的快速测定[J].理化检验-化学分册,2000,36(10):472-473.
【6】关伟宏.水玻璃模数的快速测定实验研究[J].化学工程师,2002,93(6):54-55.
相关信息
标题 | 相关频次 | |
水玻璃砂中碳酸盐含量的测定 | 2 |