Remote Field Eddy Current Testing of Low Carbon Steel Tube′s Wall Thickness Seriously Reduced Due to Corrosion
摘 要
在役换热器的低碳钢管通常用于循环水与工艺介质之间的热交换。一般情况下低碳钢管主要发生冲刷腐蚀和垢下腐蚀; 若管壁严重腐蚀减薄甚至爆管, 会影响换热器的正常运行。对换热器低碳钢管的检测, 目前最有效且快速的方法是利用涡流检测技术(ET),对发生腐蚀减薄的低碳钢管用远场涡流检测技术(RFT)测量出较准确的壁厚值, 依此可以判断低碳钢管的残余寿命, 并对该换热器的监测及技术改造提供参考依据。
Abstract
Low carbon steel tube is usually used in circulating water of the heat exchanger in service with the process medium. Normally, there exist mainly scouring corrosion and scale corrosion. In the case of tube wall being seriously thinned due to corrosion the burst might occur and the normal operation of the heat exchanger would be affected. So far the most effective and rapid method for the heat exchanger tube inspection is to use the eddy current testing technology(ET). For corrosion induced wall thickness thinning of low carbon steel tube the remote field eddy current testing technology(RFT)can accurately measure the thickness value, and this can determine the residual life of the tube. The above-mentioned method can be used to monitor the equipment and provide a reference basis for the technical innovation of the heat exchanger.
中图分类号 TG115.28 DOI 10.11973/wsjc201601016
所属栏目 实践经验
基金项目
收稿日期 2015/5/4
修改稿日期
网络出版日期
作者单位点击查看
备注杨淑海(1986-),男,助理工程师,主要从事在役压力容器的检验检测工作。
引用该论文: YANG Shu-hai. Remote Field Eddy Current Testing of Low Carbon Steel Tube′s Wall Thickness Seriously Reduced Due to Corrosion[J]. Nondestructive Testing, 2016, 38(1): 58~62
杨淑海. 严重腐蚀减薄后低碳钢管壁厚的远场涡流检测[J]. 无损检测, 2016, 38(1): 58~62
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】ASTM E2096-05 热交换器管远场涡流检测[S].
【2】孙雨施.远场涡流检测技术[M].南京: 南京航空学院出版社, 1990.
【3】任吉林, 林俊明.电磁无损检测[M].北京: 科学出版社, 2008.
【4】葛炼伟, 郭韵, 丁有广,等.核电厂高压加热器传热管涡流检测及缺陷产生机理分析[J]. 无损检测, 2014,36(1): 74-76.
【5】任吉林, 吴振成.碳纤维复合材料涂层厚度的涡流测量[J].无损检测, 2015,37(2): 5-9.
【2】孙雨施.远场涡流检测技术[M].南京: 南京航空学院出版社, 1990.
【3】任吉林, 林俊明.电磁无损检测[M].北京: 科学出版社, 2008.
【4】葛炼伟, 郭韵, 丁有广,等.核电厂高压加热器传热管涡流检测及缺陷产生机理分析[J]. 无损检测, 2014,36(1): 74-76.
【5】任吉林, 吴振成.碳纤维复合材料涂层厚度的涡流测量[J].无损检测, 2015,37(2): 5-9.
相关信息