The Reason of Excessive Fluorescent Background and the Pre-process Testing for Sheet Part
摘 要
某板材冲压零件表面检测时, 出现荧光背景过度而使得缺陷的可识别度大大降低的问题, 针对此问题进行工艺试验, 分析了荧光背景过度的成因, 并依据成因制定出了合理而有效的预处理方法。
Abstract
Aiming at the technique problem of the obvious decrement in defect distinguishing capability because of the excessive fluorescent background for batch stamped sheet part(s), this paper analyzed its cause by using process-testing and proposed a reasonable and effective pre-processing method.
中图分类号 TG115.28 DOI 10.11973/wsjc201602008
所属栏目 试验研究
基金项目
收稿日期 2015/5/7
修改稿日期
网络出版日期
作者单位点击查看
备注刘兴勇(1984-), 男, 工程师, 学士, 主要从事渗透检测工作。
引用该论文: LIU Xing-yong,XU Ya-ya. The Reason of Excessive Fluorescent Background and the Pre-process Testing for Sheet Part[J]. Nondestructive Testing, 2016, 38(2): 32~35
刘兴勇,徐亚亚. 某零件表面荧光背景过度的成因及预处理[J]. 无损检测, 2016, 38(2): 32~35
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】林猷文, 任学东.渗透检测[M].北京: 机械工业出版社, 2004.
相关信息