Gap Measurement between Steam Generator Tubes and Anti-vibration Bars Using Eddy Current Inspection
摘 要
蒸汽发生器传热管与防振条的间隙会影响传热管的微振磨损。以CPR1000机组55/19B型蒸汽发生器传热管和防振条为例, 利用旋转探头分析涡流信号与间隙距离之间的关系。结果表明, 涡流电压幅值与间隙距离间呈单调下降趋势, 可用EXCEL多项式曲线拟合, 使用时需要对曲线适当修正。
Abstract
The gaps between steam generator tubes and anti-vibration bars will affect the tube vibration wear. In this study, taking CPR1000 unit type 55/19B steam generator tube and anti-vibration bar as experiment model, rotating probe was used to establish the relationship between eddy current signal and tube-to-AVB gap. The results showed that the monotonic decrement of eddy current voltage amplitude with the increase of the gap could be represented by the EXCEL polynomial curve and the optimization of the curve was needed before its usage.
中图分类号 TG115.28 DOI 10.11973/wsjc201603018
所属栏目 试验研究
基金项目
收稿日期 2015/7/24
修改稿日期
网络出版日期
作者单位点击查看
备注孔玉莹(1984-), 女, 硕士, 工程师,主要从事核电站涡流检测与研发工作。
引用该论文: KONG Yu-ying,LI Jin-qiang,MA Qiang,BEI Ya-yao. Gap Measurement between Steam Generator Tubes and Anti-vibration Bars Using Eddy Current Inspection[J]. Nondestructive Testing, 2016, 38(3): 75~78
孔玉莹,李金强,马强,贝雅耀. 蒸汽发生器传热管与防振条间隙的涡流检测[J]. 无损检测, 2016, 38(3): 75~78
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】丁训慎.蒸汽发生器传热管的微振磨损及其防护[J].核安全,2006(3): 27-32.
【2】刘敏珊,王素珍,董其伍.防振条对蒸汽发生器U形管动态特性影响研究[J].郑州大学学报,2008,29(2): 48-51.
【3】李跃忠,韩良弼,王柏松.蒸汽发生器管束的固有振动分析[J].原子能科学技术,2008,42(增刊): 458-462.
【4】朱志斌,马强,陈文辉,等.核电站蒸汽发生器传热管缺陷涡流检测数据分析[J].无损检测,2013,35(4): 15-17.
【5】夏炎鑫,奚金妹.蒸汽发生器抗震条的装配和检测[J].锅炉技术,2004,35(3): 70-74.
【6】刘振凤,赫玲波.CPR1000蒸汽发生器的结构分析[J].一重技术,2010(3): 17-20.
【2】刘敏珊,王素珍,董其伍.防振条对蒸汽发生器U形管动态特性影响研究[J].郑州大学学报,2008,29(2): 48-51.
【3】李跃忠,韩良弼,王柏松.蒸汽发生器管束的固有振动分析[J].原子能科学技术,2008,42(增刊): 458-462.
【4】朱志斌,马强,陈文辉,等.核电站蒸汽发生器传热管缺陷涡流检测数据分析[J].无损检测,2013,35(4): 15-17.
【5】夏炎鑫,奚金妹.蒸汽发生器抗震条的装配和检测[J].锅炉技术,2004,35(3): 70-74.
【6】刘振凤,赫玲波.CPR1000蒸汽发生器的结构分析[J].一重技术,2010(3): 17-20.
相关信息