油气管道腐蚀缺陷评估方法研究综述
Review on Methods of Assessment of Corrosion defects of Oil and Gas Pipeline
摘 要
阐述了油气管道发生失效的原因及其影响, 研究分析了国外油气管道腐蚀缺陷评估方法, 并对各模型进行比选给出各类模型相对应的适用范围, 调研收集的腐蚀和管体缺陷的数据并进一步比对, 以便综合找出规律并确定模型。通过比选得出工程运用中推荐的评价方法及其模型选用。
腐蚀
缺陷
计算模型
评估
pipeline
corrosion
defect
computation model
assessment
Abstract
Explained the reasons for the occurrence of oil and gas pipeline failure and its impact. Research and analysis of foreign oil and gas pipeline corrosion defects assessment methods. And each model is given the scope of comparison of various models correspond, Some data corrosion and tube defects further than research collection. So that comprehensive order and determine the model. By comparison results using the recommended engineering evaluation method and model selection.
中图分类号 TE988
所属栏目 综合报告
基金项目
收稿日期
修改稿日期
网络出版日期
作者单位点击查看
备注张振永(1971-), 男, 汉族, 山东人, 本科, 高级工程师, 工作于中国石油天然气管道工程有限公司, 从事油气长输管道工程设计工作,
引用该论文: ZHANG Zhen-yong,ZHANG Jin-yuan,LI Chao,ZUO Si-wei. Review on Methods of Assessment of Corrosion defects of Oil and Gas Pipeline[J]. Corrosion & Protection, 2015, 36(S1): 43
共有人对该论文发表了看法，其中：
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】ASME B31G-1991 (Revision of ANSI/ASME B31G-1984). Manual for determining the remaining strength of corroded pipelines,a supplement to ASME B31 code for pressure piping[S].
【2】KIEFNER J F,VIETH P H. A modified criterion for evaluating the strength of corroded pipe[R]. Final Report for Project PR 3-805 to the Pipeline Supervisory Committee of the American Gas Association Battelle Ohio: 1989.
【3】DNV-RP-F 101. BJRNY O H,SIGURDSSON G,CRAMER E H,et al. Introduction to DNV-RP-F101 “Corroded Pipelines”, Proceedings of the 18th international conference on offshore mechanics and arctic engineering[C]//American Society of Mechanical Engineers,Newfoundland Canada: [s.n.],1999.
【4】LEIS B N,STEPHENS D R. An alternative approach to assess the integrity of corroded line pipe-part II: Alternative Criterion[C]//Proceedings of the Seventh International Offshore and Polar Engineering,[S.l.];[s.n.],1997.
【5】ZHOU W,HUANG G. Model error assessment of burst capacity models for corroded pipes[C]//Proceeding of the International Pipeline Conference,[S.l.];[s.n.],2012-90335.
【2】KIEFNER J F,VIETH P H. A modified criterion for evaluating the strength of corroded pipe[R]. Final Report for Project PR 3-805 to the Pipeline Supervisory Committee of the American Gas Association Battelle Ohio: 1989.
【3】DNV-RP-F 101. BJRNY O H,SIGURDSSON G,CRAMER E H,et al. Introduction to DNV-RP-F101 “Corroded Pipelines”, Proceedings of the 18th international conference on offshore mechanics and arctic engineering[C]//American Society of Mechanical Engineers,Newfoundland Canada: [s.n.],1999.
【4】LEIS B N,STEPHENS D R. An alternative approach to assess the integrity of corroded line pipe-part II: Alternative Criterion[C]//Proceedings of the Seventh International Offshore and Polar Engineering,[S.l.];[s.n.],1997.
【5】ZHOU W,HUANG G. Model error assessment of burst capacity models for corroded pipes[C]//Proceeding of the International Pipeline Conference,[S.l.];[s.n.],2012-90335.
相关信息
