搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
不同尖晶石含量多孔方镁石-尖晶石陶瓷的抗水泥熟料侵蚀性能
          
Cement Clinker Corrosion Resistance of Porous Periclase-Spinel Ceramics with Different Spinel Content

摘    要
将显气孔率相近(25%~29%)、不同尖晶石含量(0, 25%, 50%, 75%, 100%, 质量分数)的多孔方镁石-尖晶石陶瓷与水泥熟料在1 600 ℃下进行反应, 研究了不同尖晶石含量下该陶瓷的显微结构与抗水泥熟料侵蚀性能。结果表明: 在1 600 ℃下与水泥熟料反应时, 该陶瓷中方镁石相向水泥熟料中溶解的速率很慢, 而尖晶石相的则很快; 随着尖晶石含量的增加, 该陶瓷与水泥熟料反应时两者界面处的液相量增多, 使其被水泥熟料侵蚀的程度增大, 但同时液相黏度的增大阻止了水泥熟料的进一步渗透、减少了两者的接触面积, 降低了其侵蚀指数。
标    签 多孔方镁石-尖晶石陶瓷   尖晶石含量   水泥熟料   侵蚀性能   porous periclase-spinel ceramic   spinel content   cement clinker   corrosion resistance  
 
Abstract
The porous periclase-spinel ceramics with similar apparent porosities (25%-29%) and different spinel content (0, 25wt%, 50wt%, 75wt%, 100wt%) were reacted with cement clinker at 1 600 ℃, and the microstructures and cement clinker corrosion resistance of the ceramics with different spinel content were studied. The results show that the dissolution rate of periclase phase in the ceramic into cement clinker was slow while that of spinel phase was fast during the reaction with cement clinker at 1 600 ℃. With the increase of spinel content, the liquid phase content produced by the reaction of ceramics and cement clinker increased, resulting in the increase of the corrosion degree by the cement clinker. Meanwhile the increase of liquid phase viscosity hindered further corrosion of the cement clinker and decreased the contact area, resulting in the decrease of corrosion index.

中图分类号 TQ175.1   DOI 10.11973/jxgccl201608014

 
  中国光学期刊网论文下载说明


所属栏目

基金项目 国家自然科学基金资助项目(51302201); 湖北省自然科学基金重点资助项目(2015CFA122); 省部共建耐火材料与冶金国家重点实验室青年基金资助项目(2014QN01)

收稿日期 2015/11/23

修改稿日期 2016/4/18

网络出版日期

作者单位点击查看

备注林小丽(1992-), 女, 福建漳州人, 硕士研究生。

引用该论文: LIN Xiao-li,YAN Wen,CHEN Qing-jie,MA San-bao,LI Nan. Cement Clinker Corrosion Resistance of Porous Periclase-Spinel Ceramics with Different Spinel Content[J]. Materials for mechancial engineering, 2016, 40(8): 58~61
林小丽,鄢 文,陈庆洁,马三宝,李 楠. 不同尖晶石含量多孔方镁石-尖晶石陶瓷的抗水泥熟料侵蚀性能[J]. 机械工程材料, 2016, 40(8): 58~61


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】张巍.水泥窑用耐火材料的研究进展[J].水泥工程, 2013(2): 5-10, 23.
 
【2】范泳, 谢杰华, 陶贵华, 等.水泥窖用耐火材料的发展与展望[J].水泥技术, 2011(4): 98-100.
 
【3】YAN W,CHEN J F,LI N,et al.Preparation and characterization of porous MgO-Al2O3 refractory aggregates using an in-situ decomposition pore-forming technique[J].Ceramics International,2015,41(1A): 515-520.
 
【4】LIU G P,LI N,YAN W,et al.Composition and microstructure of a periclase composite spinel brick used in the burning zone of a cement rotary kiln[J].Ceramics International,2014,40(6): 8149-8155.
 
【5】全荣.钢包用浇注料轻量化的研究[J].耐火与石灰, 2012(6): 30-33, 37.
 
【6】YAN W,LI N,HAN B Q,et al. Effects of microsilica content on the performances of lightweight castables containing porous periclase-spinel aggregates[J].Ceram-Silikaty,2010,54: 315-319.
 
【7】YAN W,LI N,HAN B Q.Influence of microsilica content on the slag resistance of castables containing porous corundum-spinel aggregates[J].International Journal of Applied Ceramic Technology,2008,5(6): 633-640.
 
【8】YAN W,LI N,HAN B Q.An investigation on slag resistance of castable refractories containing porous spinel aggregates[J].Interceram,2009,58: 25-28.
 
【9】李楠, 鄢文.一种多孔尖晶石质陶瓷材料及其制备方法: 200610019551.8[P].2008-04-02.
 
【10】YAN W,LIN X L,CHEN J F,et al.Effect of TiO2 addition on microstructure and strength of porous spinel (MgAl2O4) ceramics prepared from magnesite and Al(OH)3[J].Journal of Alloys and Compounds,2015,618: 287-291.
 
【11】鄢文,李楠,方选明,等.熔渣对刚玉-尖晶石浇注料侵蚀的热化学模型研究[J]. 武汉科技大学学报(自然科学版),2010,33(5): 543-547.
 
相关信息
   标题 相关频次
 轻烧MA90尖晶石加入量对刚玉-尖晶石浇注料显微结构和性能的影响
 6
 00Cr17Ni14Mo2钢法兰裂纹的产生原因
 1
 0Cr18Ni9Ti不锈钢表面渗锆合金层的耐腐蚀性能及抗高温氧化性能
 1
 17-4PH不锈钢表面TiO2膜及其多层膜的结构与性能
 1
 1Cr17不锈钢表面TIG冷焊重熔和丝材熔敷工艺及改性层的组织和性能
 1
 1Cr18Ni9Ti不锈钢脉冲超窄间隙焊接头的组织及耐腐蚀性能
 1
 201不锈钢表面弧光离子镀TiN和CrN薄膜的耐蚀性
 1
 20钢多元共渗后的耐腐蚀性能
 1
 2205双相不锈钢电解腐蚀新方法
 1
 2205双相不锈钢在硫酸中的腐蚀性能
 1
 2205与15MnNiCrMoV异质钢焊接接头的耐蚀性能
 1
 304不锈钢表面锈蚀原因分析
 1
 304不锈钢表面预处理对沉积CrMoN涂层性能的影响
 1
 316LN奥氏体不锈钢在含Cl-溶液中的腐蚀行为
 1
 316L与2205不锈钢的腐蚀行为研究现状
 1
 316不锈钢表面等离子熔敷硼化物覆层的组织与性能
 1
 38CrMoAl钢表面不同厚度搪瓷涂层的组织和性能
 1
 3种成分中碳合金钢的显微组织及在含Cl-环境下的耐腐蚀性能
 1
 5A06/T2异种材料搅拌摩擦焊接头的耐蚀性
 1
 6061铝合金表面氟钛酸盐转化新工艺
 1
 6061铝合金氟钛酸盐转化膜耐蚀性能的改性研究
 1
 6061铝合金镧转化膜工艺参数的正交优化
 1
 6061铝合金上硅烷膜的制备与性能
 1
 65Mn、35Cr2Ni3MoV和AF1410在模拟海洋环境中的耐蚀性
 1
 7A04-T6铝合金中金属间化合物对其阳极氧化膜耐蚀性的影响
 1
 AA5052铝合金表面化学镀锡及其耐蚀性
 1
 AA6061-T6铝合金表面纳米Y2O3改性硅烷膜的耐蚀性
 1
 Al2O3掺杂与超声辅助对纯铝表面微弧氧化层结构与性能的影响
 1
 AlCl3-NaCl熔盐扩散增强纯镁耐腐蚀性的研究
 1
 AlCoCrFe1.5Ni高熵合金的显微组织与性能
 1