Influence of Mass Ratio of Ni to Cu and Si Content on Electrochemical Corrosion Behavior of Weathering Steel Used in Marine Environment
摘 要
采用电化学方法快速研究了不同镍铜质量比和硅含量的海洋环境用耐候钢在3.5% NaCl溶液中的电化学腐蚀行为。结果表明: 在试验范围内, 随着镍铜质量比的增大, 试验钢的自腐蚀电流密度逐渐降低; 当硅含量为低、中水平(质量分数约为0.6%, 0.9%)时, 随着镍铜质量比的增大, 自腐蚀电位逐渐正移; 当硅含量为较高水平(质量分数约为1.2%)时, 随着镍铜质量比的增大, 试验钢的自腐蚀电位变化不大; 硅含量和镍铜质量比对试验钢耐蚀性的影响存在一定的交互作用; 当镍铜质量比较低或硅含量较高时, 试验钢耐蚀性都较差; 只有当钢中碳质量分数在0.9%左右, 镍铜墙铁壁质量比为0.50时, 试验钢的耐蚀性最佳。
Abstract
Electrochemical techniques were employed to fastly investigate the electrochemical corrosion behavior of weathering steels used in marine environment in 3.5% NaCl solution. The results indicate that with the increase of mass ratio of Ni in Cu (Ni/Cu ratio), the corrosion current density of these steels was always reduced, free corrosion potential shifted in positive direction in low and middle Si content (about 0.6wt% and 0.9wt%), but hardly changed in high Si content (about 1.2wt%). The effects of Ni/Cu ratio and Si content on corrosion resistance of these steels were interactive. The corrosion resistance of test steels was bad at low Ni/Cu ratio, or in high Si content. Only when the Si content was about 0.9 wt% and Ni/Cu ratio was 0.50, the steels had the best corrosion resistance.
中图分类号 TG172 DOI 10.11973/fsyfh-201610002
所属栏目 海工材料腐蚀与防护
基金项目 国家自然科学基金资助项目(51201119)
收稿日期 2015/8/25
修改稿日期
网络出版日期
作者单位点击查看
备注黄峰(1972-), 教授, 博士, 从事金属材料腐蚀与防护及材料电化学相关研究,
引用该论文: ZHOU Xun-jun,HUANG Feng,WANG Jing-jing,CHEN Jiang-feng. Influence of Mass Ratio of Ni to Cu and Si Content on Electrochemical Corrosion Behavior of Weathering Steel Used in Marine Environment[J]. Corrosion & Protection, 2016, 37(10): 789
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】QIAN Y H,NIU D,XU J J,et al. The influence of chromium content on the electrochemical behavior of weathering steels[J]. Corrosion Science,2013,71(1)72-77.
【2】GB/T 4171-2008 耐候结构钢[S].
【3】王晶晶, 黄峰, 周学俊, 等. 合金元素对耐候钢在海洋大气中耐蚀性影响的交互作用[J]. 腐蚀与防护, 2015,36(1): 58-62.
【4】刘锟,李飞,吴耐,等. 低Ni/Cu比钢中铜的富集行为[J]. 金属热处理,2012,37(5): 29-34.
【5】李长荣,杨小平,文辉. 铜元素在钢表面氧化过程中富集规律的研究[J]. 热加工工艺,2010,39(4): 8-11.
【6】李建华, 陈士华, 陈方玉. 含铜热轧钢板表面缺陷的研究[J]. 理化检验-物理分册, 2006,42(12): 606-612.
【7】CABRERA-SIERRA R,GARCIA I,SOSA E,et al. Electrochemical behavior of carbon steel in alkaline sour environments measured by electrochemical impedance spectroscopy[J]. Electrochimica Acta,2000,46: 487-497.
【8】张鉴清. 电化学测试技术[M]. 北京: 化学工业出版社, 2010: 12.
【9】李娜. 铜在钢中的作用综述[J]. 辽宁科技大学学报, 2011,34(2): 157-162.
【10】李成涛, 程学群, 董超芳, 等. Cl-对690合金腐蚀电化学行为的影响[J]. 北京科技大学学报, 2011,33(4): 444-448.
【11】张微啸, 李成涛, 陈建军, 等. 304L不锈钢在硼酸水溶液中的腐蚀行为[J]. 腐蚀与防护, 2015,36(1): 68-71.
【2】GB/T 4171-2008 耐候结构钢[S].
【3】王晶晶, 黄峰, 周学俊, 等. 合金元素对耐候钢在海洋大气中耐蚀性影响的交互作用[J]. 腐蚀与防护, 2015,36(1): 58-62.
【4】刘锟,李飞,吴耐,等. 低Ni/Cu比钢中铜的富集行为[J]. 金属热处理,2012,37(5): 29-34.
【5】李长荣,杨小平,文辉. 铜元素在钢表面氧化过程中富集规律的研究[J]. 热加工工艺,2010,39(4): 8-11.
【6】李建华, 陈士华, 陈方玉. 含铜热轧钢板表面缺陷的研究[J]. 理化检验-物理分册, 2006,42(12): 606-612.
【7】CABRERA-SIERRA R,GARCIA I,SOSA E,et al. Electrochemical behavior of carbon steel in alkaline sour environments measured by electrochemical impedance spectroscopy[J]. Electrochimica Acta,2000,46: 487-497.
【8】张鉴清. 电化学测试技术[M]. 北京: 化学工业出版社, 2010: 12.
【9】李娜. 铜在钢中的作用综述[J]. 辽宁科技大学学报, 2011,34(2): 157-162.
【10】李成涛, 程学群, 董超芳, 等. Cl-对690合金腐蚀电化学行为的影响[J]. 北京科技大学学报, 2011,33(4): 444-448.
【11】张微啸, 李成涛, 陈建军, 等. 304L不锈钢在硼酸水溶液中的腐蚀行为[J]. 腐蚀与防护, 2015,36(1): 68-71.
相关信息