搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
氧化镁稳定氧化锆浆料的流动性和稳定性
          
Liquidity and Stability on Magnesia Stabilized Zirconia Slurry

摘    要
为了获得流动性和稳定性较好的氧化镁稳定氧化锆浆料,通过黏度测试和沉降试验,并结合Zeta电位和粒径测试,分析了固含量、分散剂加入量、浆料pH和球磨时间对浆料流动性和稳定性的影响。结果表明:随着固含量增大,浆料的黏度增大,流动性变差,稳定性增加;随着分散剂加入量和浆料pH增加以及球磨时间延长,浆料的流动性先增强后变差,稳定性先增强后趋于稳定;浆料呈碱性时,Zeta电位的绝对值较大,浆料的稳定性好;随分散剂加入量增加,Zeta电位的绝对值先增大后减小;当固含量为45%、加入稳定剂的体积分数为2%、浆料pH为9、球磨时间为48 h时,可获得流动性和稳定性均较好的陶瓷浆料。
标    签 氧化镁稳定氧化锆   浆料   流动性   稳定性   magnesia stabilized zirconia   slurry   liquidity   stability  
 
Abstract
In order to obtain magnesia stabilized zirconia slurry with good liquidity and stability, the effects of solid content, dispersant addition, slurry pH and milling time on the liquidity and stability of slurry were analyzed by viscosity test, sedimentation test and Zeta potential and particle size test. The results show that with the increase of solid content, viscosity and stability of slurry increase and liquidity decreases. Liquidity of slurry increases and then decreases, and the stability increases and then changes little as the increase of dispersant addition, slurry pH and milling time. Absolute value of Zeta potential of the alkaline slurry is larger and its stability is the best. Zeta potential increases and then decreases with the increase of dispersant addition.When the solid content was 45%, volume fraction of dispersant was 2%, slurry pH was 9 and milling time was 48 h, the ceramic slurry can obtain better liquidity and stability.

中图分类号 TQ174   DOI 10.11973/jxgccl201702010

 
  中国光学期刊网论文下载说明


所属栏目 试验研究

基金项目

收稿日期 2015/12/1

修改稿日期 2016/12/8

网络出版日期

作者单位点击查看

备注杜亚男(1988-),女,山东临沂人,工程师,硕士。

引用该论文: DU Ya-nan,XIE Jian-lin. Liquidity and Stability on Magnesia Stabilized Zirconia Slurry[J]. Materials for mechancial engineering, 2017, 41(2): 51~54
杜亚男,谢建林. 氧化镁稳定氧化锆浆料的流动性和稳定性[J]. 机械工程材料, 2017, 41(2): 51~54


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】孙静,黄传真,刘含莲,等.稳定氧化锆陶瓷的研究现状[J]. 机械工程材料,2005,29(8):1-3.
 
【2】ZHANG H, LU H, ZHU Y W,et al. Preparations and characterizations of new mesoporous ZrO2 and Y2O3-stabilized ZrO2 spherical powders[J]. Powder Technology, 2012, 22(7):9-16.
 
【3】马亚鲁,马卫兵,郑俊萍,等.少量掺杂Al2O3,SiO2的Mg-PSZ陶瓷材料的液相烧结[J].硅酸盐通报,2000(5):32-35.
 
【4】OHTSUKA H, MIZUTANI H, LIO S,et al. Effects of sintering additives on dispersion properties of Al2O3 slurry containing polyacrylic acid dispersant[J]. Journal of the European Ceramic Society, 2011, 31(4):517-522.
 
【5】CHIN C H, MUCHTAR A, AZHARI C H, et al. Optimization of pH and dispersant amount of Y-TZP suspension for colloidal stability[J]. Ceramics International, 2015, 41(8):9939-9946.
 
【6】BRISEOE B J, BIUNDO G L, OZKAN N. Drying kineties of water-based ceramic suspensions for tape casting[J]. Ceram Int, 1998, 24:347-357.
 
【7】ZVRCHER S, GRAULE T. Influence of dispersant structure on the rheological properties of highly-concentrated zirconia dispersions[J]. Euro Ceram Soc, 2005, 25(6):863-873.
 
【8】刘阳桥,高濂,孙静,等.丙烯酸类共聚物对纳米Y-TZP水悬浮液性质的影响[J]. 高等学校化学学报,2001,22(10):1738-1740.
 
【9】李明利,梁辉,徐明霞,等.分散剂用量对钛酸锶钡水基浆料稳定性的影响[J]. 硅酸盐学报,2007,35(11):1453-1456.
 
【10】周邵萍,葛晓陵.TiO2悬浮液颗粒团聚机理及团聚体分形特征研究[J]. 硅酸盐通报,2013,32(8):1680-1683.
 
【11】周芳,刘冠芳,刘斌,等.钛酸钡陶瓷浆料流变性研究[J]. 绝缘材料,2009,42(2):48-51.
 
【12】LIU T C, CHIU S J. Effect of metal loading sequence on the activity of Sn-Ni/C for methanol carbonylation[J]. Appl Catal, 1994, 117(1):17-27.
 
相关信息
   标题 相关频次
 明胶凝胶注模成型不锈钢浆料的制备与生坯的性能
 3
 不同碱度和温度条件下硫化氢溶液的稳定性研究
 2
 对甲基苯磺酰异氰酸酯的稳定性考察
 2
 高强铝合金圆筒的稳定性
 2
 管线钢管屈服强度的稳定性试验
 2
 化学镀Ni-P合金镀液稳定剂研究
 2
 基于泥浆凝固-切割的陶瓷制件快速制造技术
 2
 建筑涂料试验用无石棉纤维水泥板标准样品的定值
 2
 硫酸盐酸性光亮镀锡铋合金工艺
 2
 铝合金加筋板轴压屈曲稳定性的有限元分析
 2
 洛氏硬度计的稳定性检测
 2
 牛磺酸的稳定性及其在药酒中的测定
 2
 热处理对Al2O3陶瓷断裂韧性的影响及其工艺优化
 2
 热防护板法导热系数能力验证样品的制备工艺参数
 2
 试验研究AUT设备于100mm海底管线检验中的应用
 2
 双馈感应发电机风电机组的动态模型构建
 2
 塑料悬臂梁冲击强度检测能力验证
 2
 钛合金熔模铸造型壳用水基面层氧化锆浆料的制备
 2
 维卡软化温度测定的能力验证
 2
 稳定型硅油基磁流变液的制备及性能
 2
 新型海洋用全固态Ag/AgX复合参比电极的性能
 2
 一种水基无铬达克罗涂层的制备方法及其性能
 2
 铸态K480和DD407高温合金在长期时效过程中γ′相的稳定性
 2
 Angew. Chem.:单原子钼催化剂电催化固氮
 1
 大连化物所发表透氧膜进展报告
 1
 福建物构所稳定MOF材料研究获进展
 1
 钙对AZ91D镁合金流动性的影响
 1
 胡良兵团队 ACS Nano: 基于浆料的挤压式直写3D打印方法的新应用!
 1
 科研人员开发出液态金属图案化新方法
 1
 卢柯院士再次发表顶尖论文:纳米晶材料稳定性又一重要发现!
 1