Burst Failure of the Ceiling Tubes in a Coke Dry Quenching Furnace
摘 要
通过对宏观形貌、显微组织、非金属夹杂物、基体化学成分、表面附着物的成分和物相等进行多方面分析,探讨了某厂干熄焦(CDQ)锅炉吊顶管发生爆裂的原因。结果表明:该吊顶管靠近炉壁,且表面未被防磨罩完全覆盖,由于具有腐蚀性的高温烟气被炉壁阻挡而滞积,导致该处吊顶管所受烟气腐蚀较其他位置剧烈。吊顶管外壁在高温烟气环境中,易生成氧化皮,氧化皮被腐蚀后脱落又再生,此过程循环往复,导致管壁厚度减薄,降低了管壁的承压能力。同时,由于长期在高温环境中服役,管壁材料的老化也降低了钢管的力学性能,最终吊顶管不能承受管内压力的作用而爆管。
Abstract
By analyzing the macro morphology, microstructure observation, nonmetallic inclusions, chemical composition of substrate, component and phase analysis of the attachment on the surface, the reason for burst failure of the ceiling tubes in a coke dry quenching (CDQ) furnace was discussed. The results showed that the ceiling tube near the inner wall of the furnace without mask on the side of bursting was severely thinned by the accumulation and erosion of flue gas. In the environment of flue gas with high temperature, the oxide scale was easily formed. The oxide scale on the external surface was flaked off by corrosion and then regenerated. Circularly, the thickness of tube was reduced and the strength decreased further. Meanwhile, the steel aging of tube caused the reduced mechanical properties because of long-term service at high temperature. Finally, the ceiling tube burst due to over the limit pressure inside the tube.
中图分类号 TG172 DOI 10.11973/fsyfh-201801017
所属栏目 失效分析
基金项目
收稿日期 2016/6/15
修改稿日期
网络出版日期
作者单位点击查看
联系人作者董登超(easyddc@163.com)
引用该论文: DONG Dengchao,HONG Huimin,ZHANG Ke,WU Yuanyuan. Burst Failure of the Ceiling Tubes in a Coke Dry Quenching Furnace[J]. Corrosion & Protection, 2018, 39(1): 78
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】周亚平. 干熄焦锅炉的设计研究[J]. 冶金动力,2006(2):6-8.
【2】杜屏,吴波,陈军伟,等. 干熄焦炉防磨罩耐磨涂层喷涂技术的应用[J]. 有色金属科学与工程,2015,6(2):1-6.
【3】潘立慧,魏松波. 干熄焦技术[M]. 北京:冶金工业出版社,2005.
【4】美国金属学会. 金属手册[M]. 8版. 北京:机械工业出版社,1986:771-797.
【5】王敏. 锅炉水冷壁腐蚀及爆裂的原因分析和防止对策[J]. 腐蚀与防护,2006,27(4):215-216.
【6】张而耕,童遂放,王琼琦,等. 12Cr1MoV珠光体耐热钢长期服役中碳化物的变化及对性能的影响[J]. 机械工程材料,2009,33(9):28-32.
【7】刘高杰,李希超,任相文. 电站高温再热器爆管分析[J]. 理化检验-物理分册,2003,39(2):361-363.
【2】杜屏,吴波,陈军伟,等. 干熄焦炉防磨罩耐磨涂层喷涂技术的应用[J]. 有色金属科学与工程,2015,6(2):1-6.
【3】潘立慧,魏松波. 干熄焦技术[M]. 北京:冶金工业出版社,2005.
【4】美国金属学会. 金属手册[M]. 8版. 北京:机械工业出版社,1986:771-797.
【5】王敏. 锅炉水冷壁腐蚀及爆裂的原因分析和防止对策[J]. 腐蚀与防护,2006,27(4):215-216.
【6】张而耕,童遂放,王琼琦,等. 12Cr1MoV珠光体耐热钢长期服役中碳化物的变化及对性能的影响[J]. 机械工程材料,2009,33(9):28-32.
【7】刘高杰,李希超,任相文. 电站高温再热器爆管分析[J]. 理化检验-物理分册,2003,39(2):361-363.
相关信息