Coiling Temperature Optimization of Hot-Rolled X80M Pipeline Steel Plate
摘 要
在卷取温度分别为300,350,400,450℃下对18.4 mm×1 550 mm规格的X80M管线钢板进行卷取,研究了卷取温度控制的稳定性以及卷取后钢板的显微组织和力学性能,并对卷取温度进行了优化。结果表明:随着卷取温度的升高,实测卷取温度的稳定性逐渐增大;在300~450℃卷取后,试验钢的显微组织均为针状铁素体,力学性能满足技术要求,且强度、低温韧性均有一定的富余量;优化后的卷取温度为380℃,在该温度卷取后试验钢的各项力学性能良好。
Abstract
An X80M pipeline steel plate with specification of 18.4 mm×1 550 mm was coiled at different coiling temperatures of 300, 350, 400, 450℃, respectively. The control stability of the coiling temperature and the microstructure and mechanical properties of the coiled steel plate were studied. The coiling temperature was optimized. The results show that the stability of the measured coiling temperatures increased with the coiling temperature rising. The microstructure of the tested steel consisted of acicular ferrite after coiling at 300-450℃; the mechanical properties met the technical requirements, with a certain allowance of both strength and low-temperature toughness. The optimal coiling temperature was 380℃. The tested steel coiled at this temperature had good mechanical properties.
中图分类号 TG335.5 DOI 10.11973/jxgccl201803006
所属栏目 试验研究
基金项目
收稿日期 2017/1/15
修改稿日期 2017/10/27
网络出版日期
作者单位点击查看
备注程政(1985-),男,河南安阳人,工程师,硕士
引用该论文: CHENG Zheng,MIAO Chengliang,ZHU Tengwei,YANG Xiaohe,XU Haiwei,CHEN Yi. Coiling Temperature Optimization of Hot-Rolled X80M Pipeline Steel Plate[J]. Materials for mechancial engineering, 2018, 42(3): 33~37
程政,缪成亮,朱腾威,杨孝鹤,徐海卫,陈一. X80M管线钢热轧板卷取温度的优化[J]. 机械工程材料, 2018, 42(3): 33~37
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】庄传晶,冯耀荣,霍春勇,等. 国内X80级管线钢的发展及今后的研究方向[J]. 焊管,2005,28(2):10-14.
【2】张伟卫,熊庆人,吉玲康,等. 国内管线钢生产应用现状及发展前景[J]. 焊管,2011,34(1):5-8.
【3】张国柱,宋志超,张红梅,等. 卷取温度对X80管线钢组织和性能的影响[J]. 机械工程材料,2010,34(2):25-26.
【4】牛涛,姜永文,李飞,等. 卷取温度对0.8设计系数X80管线钢显微组织与力学性能的影响[J]. 机械工程材料,2016,40(2):89-93.
【5】汪贺模,蔡庆伍,余伟,等. 水流量对热轧钢板层流冷却过程对流换热系数的影响[J]. 北京科技大学学报,2012,34(12):1421-1425.
【6】贺信莱,尚成嘉,杨善武,等. 高性能低碳贝氏体钢[M].北京:冶金工业出版社,2008:58-76.
【2】张伟卫,熊庆人,吉玲康,等. 国内管线钢生产应用现状及发展前景[J]. 焊管,2011,34(1):5-8.
【3】张国柱,宋志超,张红梅,等. 卷取温度对X80管线钢组织和性能的影响[J]. 机械工程材料,2010,34(2):25-26.
【4】牛涛,姜永文,李飞,等. 卷取温度对0.8设计系数X80管线钢显微组织与力学性能的影响[J]. 机械工程材料,2016,40(2):89-93.
【5】汪贺模,蔡庆伍,余伟,等. 水流量对热轧钢板层流冷却过程对流换热系数的影响[J]. 北京科技大学学报,2012,34(12):1421-1425.
【6】贺信莱,尚成嘉,杨善武,等. 高性能低碳贝氏体钢[M].北京:冶金工业出版社,2008:58-76.
相关信息