Radiography Testing for TC4 Alloy Additive Manufacturing Parts in 15 mm Thickness
摘 要
以15 mm厚度TC4合金增材制造自然缺陷试样为对象,研究其射线照相检测工艺及灵敏度,并采用90°翻转照相、工业CT断层扫描技术进行验证。试验验证结果表明:射线照相检测可检出15 mm厚度TC4合金增材制造制件中直径为0.4~0.5 mm的孔洞缺陷,然而同射线照相透视成像相比,工业CT断层扫描成像技术更有助于缺陷的定位和定量。
Abstract
The paper carries out research on radiography testing process and its sensitivity for TC4 alloy additive manufacturing parts of 15 mm thickness with natural defect. The test results were verified by the use of 90° overturn testing and industry computed tomography. Radiography testing can detect pore defect of 0.4-0.5 mm in 15 mm thickness TC4 alloy additive manufacturing parts. However, comparing with radiography testing, industrial computed tomography greatly avails for positioning and quantifying the defects.
中图分类号 TG115.28 DOI 10.11973/wsjc201806006
所属栏目 试验研究
基金项目
收稿日期 2018/2/26
修改稿日期
网络出版日期
作者单位点击查看
备注周炳如(1962-),男,工程师,主要从事无损检测技术的应用研究工作
引用该论文: ZHOU Bingru,WANG Bingyang,ZHOU Yanxian,ZHANG Jie,YANG Guang. Radiography Testing for TC4 Alloy Additive Manufacturing Parts in 15 mm Thickness[J]. Nondestructive Testing, 2018, 40(6): 21~24
周炳如,王丙阳,周言贤,张杰,杨光. 15 mm厚度TC4合金增材制造制件的射线照相检测[J]. 无损检测, 2018, 40(6): 21~24
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】北京航空制造工程研究所.航空制造技术[M].北京:航空工业出版社,2013.
【2】巩水利,锁红波,李怀学.金属增材制造技术在航空领域的发展与应用[J].航空制造技术,2013(13):66-71.
【3】张学军,唐思熠,肇恒跃,等. 3D打印技术研究现状和关键技术[J].材料工程,2016,44(2):122-128.
【2】巩水利,锁红波,李怀学.金属增材制造技术在航空领域的发展与应用[J].航空制造技术,2013(13):66-71.
【3】张学军,唐思熠,肇恒跃,等. 3D打印技术研究现状和关键技术[J].材料工程,2016,44(2):122-128.
相关信息