搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
基于涡流效应的线圈阵列传感器设计与神经网络检测算法
          
The Design of Coil Array Sensor Based on Eddy Current Effect and Neural Network Detection Algorithm

摘    要
针对传统混凝土内部检测方式,只能测量混凝土保护层厚度,而无法同时对钢筋直径进行有效测量的问题,提出了一种基于脉冲涡流阵列的新型检测装置。使用ANSOFT仿真软件对检测模型进行仿真分析,并通过试验,验证了该检测模型对于混凝土保护层厚度以及钢筋直径具有较好的响应效果。通过BP神经网络建立了线圈信号和保护层厚度、钢筋直径之间的数学模型。试验结果基本满足精度要求,弥补了传统涡流检测仪器无法同时完成对保护层厚度与钢筋直径测量的不足。
标    签 无损检测   脉冲线圈阵列   BP神经网络   STM 32单片机   nondestructive testing   pulsed eddy current array   BP neural network   STM 32 single chip  
 
Abstract
In respect that the diameter of steel bar inside of concrete could not be measured effectively in traditional method, a new type of detection device based on pulsed eddy current array was proposed to detect both the thickness of concrete protective layer and the diameter of steel bar simultaneously. The detection model was simulated by ANSOFT simulation software, and physical experiments verified that the model had a good response to the thickness of the concrete protective layer and the diameter of the steel bar. Then, the BP neural network was used to establish the mathematical relationship of the coil signal to the thickness the protective layer and the diameter of the steel bar. The result of neural network experiment satisfied with the requirement basically. The new type of detection device could measure both the thickness of concrete protective layer and the diameter of steel bar at the same time, which the traditional eddy current detection equipment could not complete.

中图分类号 TG115.28   DOI 10.11973/wsjc201807010

 
  中国光学期刊网论文下载说明


所属栏目 试验研究

基金项目 国家自然科学基金资助项目(51575246)

收稿日期 2018/1/31

修改稿日期

网络出版日期

作者单位点击查看


备注李天博(1969-),男,副教授,主要研究方向为控制理论与控制工程、传感器与检测技术、物联网技术等

引用该论文: LI Tianbo,YIN Yuhan,LI Yangyang. The Design of Coil Array Sensor Based on Eddy Current Effect and Neural Network Detection Algorithm[J]. Nondestructive Testing, 2018, 40(7): 43~48
李天博,尹玉瀚,李洋洋. 基于涡流效应的线圈阵列传感器设计与神经网络检测算法[J]. 无损检测, 2018, 40(7): 43~48


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】王茹, 邵珍奇. 雷达技术在混凝土结构无损检测中的应用[J]. 核电子学与探测技术, 2009, 29(2):459-462.
 
【2】程守洙, 江之永. 普通物理学[M].北京:高等教育出版社, 2006.
 
【3】SILVESTER P. Eddy-current modes in linear solid-iron bars[J].Proceedings of the Institution of Electrical Engineers, 2010, 112(8):1589-1594.
 
【4】李天博, 刘守华, 陈坤华. 脉冲涡流阵列检测系统仿真与实验[J]. 磁性材料及器件, 2013(6):26-30.
 
【5】TIAN L, YIN C, CHENG Y, et al. Successive approximation method for the measurement of thickness using pulsed eddy current[C]//Instrumentation and Measurement Technology Conference.[S.l.]:[s.n.], 2015:848-852.
 
【6】周德强, 潘萌, 常祥,等. 铁磁性构件缺陷的脉冲涡流检测模式研究[J]. 仪器仪表学报, 2017, 38(6):1498-1505.
 
【7】张震. 脉冲涡流测厚技术研究[D]. 西安:西安理工大学, 2007.
 
【8】BUCK J A, UNDERHILL P R, MORELLI J E, et al. Simultaneous multiparameter measurement in pulsed eddy current steam generator data using artificial neural networks[J]. IEEE Transactions on Instrumentation and Measurement, 2016, 65(3):672-679.
 
【9】熊亮, 赵俊锴. 基于RBF神经网络的变电站混凝土立柱抗压强度评定[J].无损检测,2015,37(5):52-54.
 
相关信息
   标题 相关频次
 20CrMnTi钢渗碳淬火硬化层深度的磁矫顽力检测
 2
 300M钢热损伤的巴克豪森检测
 2
 35号冷轧钢在不同阶段应力作用下的磁效应特征
 2
 6061铝合金/DP590钢冷金属过渡焊接工艺参数优化与变形预测
 2
 ASNT SNT-TC-1A人员认证在我国的发展情况
 2
 BP神经网络+磁记忆检测:更早预警油气管道潜在缺陷
 2
 CNDT&E“云”检测与评价技术
 2
 DR检测技术在空调零部件焊接领域的应用
 2
 Excel软件在无损检测资料整理中的应用
 2
 FRP片材加固界面补丁式剥离损伤的光纤检测技术
 2
 GIS盆式绝缘子模拟缺陷的X-DR成像检测
 2
 ISO 17635:2010标准主要规定内容及其国内应用现状
 2
 ISO 9712-2012与TSGZ 8001-2019标准的主要异同解析
 2
 L458M钢管道无损检测缺陷产生原因
 2
 NB/T47013-2015《承压设备无损检测》中工艺验证的实施方法
 2
 NDT集成新技术时代的到来
 2
 TaW薄板分层缺陷检测及成因分析
 2
 TMR传感器及其在电磁检测中的应用
 2
 WiFi无线技术在巴克豪森无损检测系统中的应用
 2
 X射线数字成像技术在预应力索灌浆质量检测中的应用
 2
 奥氏体不锈钢中径管焊缝超声爬波探伤
 2
 奥氏体不锈钢中马氏体含量的相关无损检测方法
 2
 奥氏体锅炉管氧化皮堆积厚度脉冲涡流检测
 2
 波音飞机无损检测手册编制方法
 2
 玻璃钢缺陷的空耦激光超声检测
 2
 薄板结构中Lamb波的检测与仿真
 2
 残余应力的超声检测方法
 2
 测控技术与仪器(无损检测)专业培养计划分析与探索
 2
 层压结构复合材料的激光剪切散斑检测
 2
 场(厂)内机动车辆无损检测技术
 2