搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
阳极氧化工艺及改性对TiO2纳米管阵列薄膜疏水性的影响
          
Effect of Anodizing Process and Modification on Hydrophobicity of TiO2 Nanotube Array Film

摘    要
采用阳极氧化法在钛片表面制备TiO2纳米管阵列薄膜,研究了不同氧化电压(15~25 V)和时间(0.5~2 h)下薄膜的微观结构;采用硬脂酸对其进行改性,分析了薄膜改性前后的润湿性能。结果表明:TiO2纳米管平均管径和管间距随氧化电压增大而增大,随氧化时间的变化不明显,而表面结构均匀性则受氧化时间影响,氧化2 h的结构均匀性较好;改性前薄膜表面呈亲水性,改性后呈疏水性,且改性前越亲水则改性后越疏水;氧化时间对改性薄膜水接触角的影响较大,不同电压下阳极氧化2 h制备得到薄膜改性后均呈超疏水性,20 V/2 h下制备得到薄膜改性后的平均水接触角最大,可达159.7°。
标    签 阳极氧化法   TiO2纳米管阵列   改性   疏水性   亲水性   anodizing method   TiO2 nanotube array   modification   hydrophobicity   hydrophilcity  
 
Abstract
The TiO2 nanotube array film was prepared on the titanium sheet surface by anodizing method, and the microstructure of the film prepared at different anodizing voltages (15-25 V) and times (0.5-2 h)was studied. Then the film was modified by stearic acid. The wetting performance of the film before and after modification was analyzed. The results show that the average diameter and tube spacing of TiO2 nanotube increased with increasing anodizing voltage, but did not changed obviously with the anodizing time. The surface structure uniformity was affected by the anodizing time, and the structure uniformity after anodizing for 2 h was realtively good. The surface of the film before modification was hydrophilic, and after modification was hydrophobic. The more hydrophilic the film before modification, the more hydrophobic after modification. The anodizing time had a greater effect on the water contact angle of the modified film. The films prepared by anodizing at different voltages for 2 h were all superhydrophobic after modification. The average water contact angle of the modified film prepared at 20 V/2 h was the highest, and the value was 159.7°.

中图分类号 TG174.4   DOI 10.11973/jxgccl202104002

 
  中国光学期刊网论文下载说明


所属栏目 试验研究

基金项目 南通市市级科技计划项目(JC2018113);中央高校基本科研业务费项目(2017B16114, B200205001)

收稿日期 2021/1/11

修改稿日期 2021/3/11

网络出版日期

作者单位点击查看

备注李雷(1994-),男,湖南长沙人,硕士研究生

引用该论文: LI Lei,JIANG Shaoqun,WANG Gang,XU Yi,ZHOU Zehua. Effect of Anodizing Process and Modification on Hydrophobicity of TiO2 Nanotube Array Film[J]. Materials for mechancial engineering, 2021, 45(4): 8~12
李雷,江少群,王刚,徐怡,周泽华. 阳极氧化工艺及改性对TiO2纳米管阵列薄膜疏水性的影响[J]. 机械工程材料, 2021, 45(4): 8~12


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】ONDA T, SHIBUICHI S, SATOH N, et al. Super-water-repellent fractal surfaces[J].Langmuir,1996,12(9):2125-2127.
 
【2】WANG B,PENG S,WANG Y C,et al.A non-fluorine method for preparing multifunctional robust superhydrophobic coating with applications in photocatalysis,flame retardance,and oil-water separation[J].New Journal of Chemistry,2019,43(19):7471-7481.
 
【3】WANG N,XIONG D,DENG Y,et al.Mechanically robust superhydrophobic steel surface with anti-icing,UV-durability,and corrosion resistance properties[J].ACS Applied Materials & Interfaces,2015,7(11):6260-6272.
 
【4】DEY S, CHATTERJEE S, SINGH B P, et al. Development of superhydrophobic corrosion resistance coating on mild steel by electrophoretic deposition[J]. Surface and Coatings Technology, 2018, 341:24-30.
 
【5】FIHRI A, BOVERO E, AL-SHAHRANI A, et al. Recent progress in superhydrophobic coatings used for steel protection:A review[J]. Colloids & Surfaces:A Physicochemical & Engineering Aspects, 2017, 520:378-390.
 
【6】BARATI D G, ALIOFKHAZRAEI M, KHORSAND S, et al. Science and engineering of superhydrophobic surfaces:Review of corrosion resistance, chemical and mechanical stability[J]. Arabian Journal of Chemistry, 2020, 13(1):1763-1802.
 
【7】WANG P,ZHANG D,QIU R.Liquid/solid contact mode of super-hydrophobic film in aqueous solution and its effect on corrosion resistance[J].Corrosion Science,2012,54(1):77-84.
 
【8】薛超瑞.二氧化钛纳米管阵列的制备、超疏水改性及耐蚀性能研究[D].青岛:中国海洋大学,2011. XUE C R. Preparation and superhydrophobic modification of TiO2 nanotube arrays and research on its anticorrosion properties[D]. Qingdao:Ocean University of China, 2011.
 
【9】SMITH Y R, KAR A, SUBRAMANIAN V. Investigation of physicochemical parameters that influence photocatalytic degradation of methyl orange over TiO2 nanotubes[J]. Industrial & Engineering Chemistry Research, 2009, 48(23):10268-10276.
 
【10】GAO Z Q,YANG S G,SUN C,et al.Microwave assisted photocatalytic degradation of pentachlorophenol in aqueous TiO2 nanotubes suspension[J].Separation and Purification Technology,2007,58(1):24-31.
 
【11】郑青,周保学,白晶,等.TiO2纳米管阵列及其应用[J].化学进展,2007,19(1):117-122. ZHENG Q, ZHOU B X, BAI J, et al. Titanium oxide nanotube arrays and their applications[J]. Progress in Chemistry, 2007, 19(1):117-122.
 
【12】ZHAO D,YANG X,CHEN C,et al.Enhanced photocatalytic degradation of methylene blue on multiwalled carbon nanotubes-TiO2[J].Journal of Colloid and Interface Science,2013,398:234-239.
 
【13】李静,云虹,林昌健.TiO2纳米管阵列的制备及其对316不锈钢光生阴极保护作用的研究[J].电化学,2007,13(4):367-371. LI J, YUN H, LIN C J. Preparation and investigations on the TiO2 nanotube arrays for cathodic protection of 316L stainless steel[J]. Electrochemistry, 2007, 13(4):367-371.
 
【14】漆海清,朱燕峰,张娟,等.TiO2纳米管阵列膜的制备及对304不锈钢的光生阴极保护效应[J].功能材料,2012,43(9):1147-1150. QI H Q, ZHU Y F, ZHANG J, et al. Study on the TiO2 nanotube array films for photocathodic protection of 304 stainless steel[J]. Journal of Functional Materials, 2012, 43(9):1147-1150.
 
【15】LIN Z Q, LAI Y K, HU R G, et al. A highly efficient ZnS/CdS@TiO2 photoelectrode for photogenerated cathodic protection of metals[J]. Electrochimica Acta, 2010, 55(28):8717-8723.
 
【16】王晔.细长钛管内表面TiO2微纳结构的可控制备及疏水改性研究[D].重庆:重庆大学,2017. WANG Y. Controllable preparation and hydrophobic modification of TiO2 micro-nanostructures at the inner surface of slender titanium tubes[D]. Chongqing:Chongqing University, 2017.
 
【17】景宝. 阳极氧化法制备TiO2薄膜及其超疏水改性[D]. 北京:北方工业大学, 2015. JING B. Preparation of TiO2 nano-film by anodic oxidation method and its hydrophobic modification[D]. Beijing:North China University of Technology, 2015.
 
【18】柳堤,江少群,王刚,等.阳极氧化制备工艺对TiO2纳米管阵列显微形貌的影响[J].中国表面工程,2017,30(6):67-74. LIU D, JIANG S Q, WANG G, et al. Effects of anodic oxidation process on morphologies of TiO2 nanotube arrays[J]. China Surface Engineering, 2017, 30(6):67-74.
 
【19】WENZEL R N. Resistance of solid surface to wetting by water[J]. Industrial & Engineering Chemistry, 1936, 28(8):988-994.
 
【20】NG W F, WONG M H, CHENG F T. Stearic acid coating on magnesium for enhancing corrosion resistance in Hanks' solution[J]. Surface and Coatings Technology, 2010, 204(11):1823-1830.
 
相关信息
   标题 相关频次
 w(Ti+B4C+C)/w(Ni60A)对等离子熔覆镍基复合涂层结构与性能的影响
 6
 12Cr1MoV钢在碱金属硫氯盐中的腐蚀行为
 2
 304奥氏体不锈钢高温拉伸变形时的锯齿流变行为
 2
 40Cr钢等温淬火形成的下贝氏体组织形貌特征
 2
 45钢减速器轴断裂原因分析
 2
 60Si2MnA钢片弹簧断裂失效分析
 2
 ER50-6热轧盘条拉拔断裂原因分析
 2
 KH-570/SiO2配比对Al2O3-13% TiO2封孔涂层耐酸腐蚀性能的影响
 2
 Q195钢盘条折弯开裂原因分析
 2
 Q345B低碳钢/20Mn23Al无磁钢异种钢焊接接头的组织及性能
 2
 QT400-18L铸件的缩松缺陷对其力学性能的影响
 2
 REGT1低碳薄钢板加工油桶穿孔渗漏原因分析
 2
 SCAL型间冷系统中碳钢腐蚀产物对铝腐蚀行为的影响
 2
 钡盐改性常温锌钙系磷化液
 2
 钡盐改性清洁型常温锌锰系磷化液
 2
 丙烯酸基水性金属防腐蚀涂料的研究与应用进展
 2
 常减压蒸馏装置的腐蚀调查与分析
 2
 常减压蒸馏装置塔顶系统的腐蚀机理与防护措施
 2
 超声激励封孔对等离子喷涂Al2O3-13% TiO2涂层耐腐蚀性能的影响
 2
 等离子熔覆镍铬碳合金层的显微组织和硬度
 2
 多主元高熵合金AlFeCuCoNiCr的微观结构
 2
 二次掺杂聚苯胺的防腐蚀性能
 2
 反应等离子喷涂技术的研究进展
 2
 反应等离子熔覆原位合成WC增强铁基合金涂层的工艺优化
 2
 防海生物污损材料研究现状
 2
 酚醛改性环氧树脂应用案例分析
 2
 粉末X射线衍射法测定醛气相加氢催化剂
 2
 腐蚀缺陷漏磁场检测有限元模拟
 2
 改性膨胀石墨基炭/炭复合材料对甲醛气体的吸附性能
 2
 高效液相色谱-串联质谱联用测定鳗鱼中孔雀石绿、结晶紫及其代谢物残留量
 2