Evaluation of dye penetrant testing for chromium plating of CRDM latch assembly
摘 要
核电站控制棒驱动机构(CRDM)中钩爪部件的关键配合面采用镀铬处理,镀铬层着色渗透检测的难点是较难精确评定着色渗透检测所发现的粉红色显示的类型及严重程度。结合不同检测条件对着色渗透检测的影响,分析总结了各类粉红色显示的差异,排除了“未充分清洗”造成粉红色显示的可能。
Abstract
The key mating surfaces of the latch assembly in the control rod drive mechanism (CRDM) of nuclear power plant are chrome-plated. The difficulty with this chromium plating inspection is that it is difficult to accurately evaluate the type and severity of the pink indication found in the dye penetrant testing. Based on the influence of different inspection conditions of dye penetrant testing, this paper analyzes and summarizes the differences of various pink indications, and excludes the possibility of pink indication caused by “insufficient cleaning”.
中图分类号 TG115.28 DOI 10.11973/wsjc202107014
所属栏目 实践经验
基金项目
收稿日期 2020/10/9
修改稿日期
网络出版日期
作者单位点击查看
备注胡海涛(1984-),男,本科,高级工程师,主要从事核电无损检测工作
引用该论文: HU Haitao,LI Hui. Evaluation of dye penetrant testing for chromium plating of CRDM latch assembly[J]. Nondestructive Testing, 2021, 43(7): 60~63
胡海涛,李辉. 核电站控制棒驱动机构钩爪部件镀铬层着色渗透检测的评定[J]. 无损检测, 2021, 43(7): 60~63
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
相关信息