Radiographic testing of BOSS welding seam of condenser tank for nuclear power plant
摘 要
根据冷凝罐BOSS焊缝(小支管与筒体的安放式角焊缝)的制造工艺和结构特点,结合客户对BOSS焊缝体积型缺陷的检测要求,参照标准RCC-M-2007 《压水堆核岛机械设备设计与建造规则》 制定了冷凝罐BOSS焊缝的射线检测工艺,并进行射线检测试验和工艺验证。射线检测结果符合检测相关标准要求,检测效果非常显著。根据检测出的缺陷类型,改进了制造工艺,提高了产品合格率。
Abstract
According to the manufacturing process and structural characteristics of the BOSS welding seam(Placement fillet weld between small branch pipe and cylinder) of the condensing tank, combined with the customer's requirements for the detection of BOSS welding seam defects, and referring to the standard RCC-M-2007 “Design and construction rules for pressurized water reactor nuclear island mechanical equipment”, the condensation Radiographic inspection process of tank BOSS welds was drafted, and radiographic inspection test and process verification were correspondingly conducted. The radiographic inspection results meet the requirements of relevant inspection standards, and the inspection results are very significant. According to the types of defects detected, the manufacturing process is improved and the product qualification rate is increased.
中图分类号 TG115.28 DOI 10.11973/wsjc202109016
所属栏目 实践经验
基金项目
收稿日期 2021/3/23
修改稿日期
网络出版日期
作者单位点击查看
备注孙彪(1988-),男,助理工程师,主要从事特种设备及核二、三级核电设备的无损检测工作
引用该论文: SUN Biao,YAN Chao,MENG Shuai,CHENG Hongxia,MIAO Changying,YUAN Yu. Radiographic testing of BOSS welding seam of condenser tank for nuclear power plant[J]. Nondestructive Testing, 2021, 43(9): 73~76
孙彪,闫超,孟帅,程宏霞,苗畅颖,原瑜. 核电用冷凝罐BOSS焊缝的射线检测[J]. 无损检测, 2021, 43(9): 73~76
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】吴伟邦, 许金才.核电BOSS头焊缝无损检测要求[J].无损检测,2018,40(3):51-55.
相关信息