基于COMSOL的多金属耦合腐蚀行为仿真
Simulation of Multi-Metal Coupling Corrosion Behavior Based on COMSOL
摘 要
将多金属耦合体系拆分为多个双金属电偶,采用有限元仿真软件COMSOL,对比分析了各双金属电偶间耦合电流的大小,建立了基于中间电位金属的多金属耦合腐蚀模型阴、阳极状态的判断方法。以高强钢,B10铜镍合金和TA2钛合金三金属耦合体系为例,模拟研究了电极排序与阴/阳极面积比对多金属耦合体系腐蚀行为的影响。结果表明:在不同电极排序条件下,中间电位金属B10铜镍合金均作为阴极参与电偶腐蚀;当电极排序相同时,耦合体系中高强钢表面的电流密度随着B10与TA2面积占比的增加而增加;不同电极排序耦合体系中高强钢表面的电流密度按从大到小的顺序依次为B10铜镍合金-高强钢-TA2钛合金、高强钢-B10铜镍合金-TA2钛合金、B10铜镍合金-TA2钛合金-高强钢。
COMSOL
高强钢
铜镍合金
钛合金
电偶腐蚀
multi-metal coupling
COMSOL
high-strength steel
copper nickel alloy
titanium alloy
galvanic corrosion
Abstract
Disassembling a multi-metal coupling system into multiple dual-metal galvanic couples, and using the finite element simulation software COMSOL to compare the magnitude of the coupling current between dual-metal galvanic couples, a method to judge the cathode and anode states of the multi-metal coupling corrosion model based on intermediate potential metal was established. Taking high strength steel, B10 copper nickel alloy and TA2 titanium alloy triple metal coupling system as an example, the effects of the comparison of electrode ordering and cathode/anode area ratio of the multi-metal coupling system were simulated. The results showed that under different electrode ordering conditions, the intermediate potential metal B10 copper nickel alloy was always used as a cathode to participate in galvanic corrosion. When the electrode ordering was the same, the current density on the surface of high strength steel of coupling system was increased with the increase of B10 and TA2 area ratio. The current density on surface of high strength steel of coupling system of different electrode ordering was B10 copper nickel alloy-high strength steel-TA2 titanium alloy, high strength steel-B10 copper nickel alloy-TA2 titanium alloy, B10 copper nickel alloy-TA2 titanium alloy-high-strong strength steel.
中图分类号 TG174 DOI 10.11973/fsyfh-202209011
所属栏目 数值模拟
基金项目
收稿日期 2020/7/7
修改稿日期
网络出版日期
作者单位点击查看
引用该论文: SHI Pengfei,DUAN Guoqing,GUO Qian,YANG Wenshan,LU Yunfei. Simulation of Multi-Metal Coupling Corrosion Behavior Based on COMSOL[J]. Corrosion & Protection, 2022, 43(9): 59
共有人对该论文发表了看法，其中：
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】刘华剑,邓春龙,王佳,等.海洋环境中电偶腐蚀研究进展[J].装备环境工程,2011,8(2):58-61.
【2】朱相荣,黄桂桥.金属材料在海水中的接触腐蚀研究[J].海洋科学,1994,18(6):55-59.
【3】MANSFELD F. Area relationships in galvanic corrosion[J]. Corrosion,1971,27(10):436-442.
【4】潘大伟,闫永贵,高心心,等.高强钢与典型管系材料B10和TA2之间的电偶腐蚀及其电绝缘[J].腐蚀与防护,2017,38(8):589-592,597.
【5】张海丽,李宁,薛建军,等.工业纯钛与铜镍合金的电偶腐蚀及电绝缘控制[J].腐蚀与防护,2010,31(8):615-618.
【6】王春丽.海洋环境复杂偶合体系腐蚀行为研究[D].哈尔滨:哈尔滨工程大学,2013.
【7】胡强飞.电偶腐蚀的计算机模拟[D].沈阳:东北大学,2015.
【2】朱相荣,黄桂桥.金属材料在海水中的接触腐蚀研究[J].海洋科学,1994,18(6):55-59.
【3】MANSFELD F. Area relationships in galvanic corrosion[J]. Corrosion,1971,27(10):436-442.
【4】潘大伟,闫永贵,高心心,等.高强钢与典型管系材料B10和TA2之间的电偶腐蚀及其电绝缘[J].腐蚀与防护,2017,38(8):589-592,597.
【5】张海丽,李宁,薛建军,等.工业纯钛与铜镍合金的电偶腐蚀及电绝缘控制[J].腐蚀与防护,2010,31(8):615-618.
【6】王春丽.海洋环境复杂偶合体系腐蚀行为研究[D].哈尔滨:哈尔滨工程大学,2013.
【7】胡强飞.电偶腐蚀的计算机模拟[D].沈阳:东北大学,2015.
相关信息
