Influencing factors on resolution of CCTV inspection of the pressurizerinternal surface of nuclear power plant
摘 要
分析了华龙一号压水堆核电机组稳压器内表面堆焊层CCTV(闭路电视监控系统)检测过程中摄像头分辨率和放大率、照明类型、被检对象、表面状况和查扫速度等因素对检测分辨率的影响,提出可以通过提高摄像头与监视器的分辨率、采用漫反射同轴光、提供充足照明、采用足够慢的扫查速度、改善表面状况等措施提高CCTV检测分辨率;同时,采取有效的图像处理措施,可增强缺陷典型特征及分辨率,从而提高缺陷检出率。
Abstract
This paper analyses the influence of factors such as camera resolution and magnification, lighting type, surface condition, and scanning speed on the inspection resolution of CCTV (closed-circuit television monitoring system) inspection of the inner surface surfacing layer of Hualong No. 1 pressurised water reactor core power unit voltage regulator. It proposes to improve the CCTV inspection resolution by improving the resolution of the camera and monitor, using diffuse coaxial light and providing sufficient lighting. It also suggests to adopt sufficiently slow scanning speed, improving surface conditions and other measures. At the same time, effective image processing measures can enhance the typical characteristics and resolution of defects, so as to improve the detection rate of defect detection.
中图分类号 TG115.28 DOI 10.11973/wsjc202212016
所属栏目 实践经验
基金项目
收稿日期 2022/5/19
修改稿日期
网络出版日期
作者单位点击查看
备注刘军(1981-),男,本科,高级工程师,主要研究方向为PT/VT无损检测
引用该论文: LIU Jun,YAN Zhigang,SHI Lei. Influencing factors on resolution of CCTV inspection of the pressurizerinternal surface of nuclear power plant[J]. Nondestructive Testing, 2022, 44(12): 76~80
刘军,严志刚,石磊. 核电站稳压器内表面堆焊层CCTV检测分辨率的影响因素[J]. 无损检测, 2022, 44(12): 76~80
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】陶于春,梁瞻翔,林忠元,等. 压水堆核电站在役检查用无损检测技术发展概况[J]. 无损检测,2009,31(12):959-966.
【2】李玉龙,彭志珍,夏朋. 间接目视检测技术在CPR1000机组在役检查中的应用[J]. 科技信息,2014(1):68-70.
【2】李玉龙,彭志珍,夏朋. 间接目视检测技术在CPR1000机组在役检查中的应用[J]. 科技信息,2014(1):68-70.
相关信息