Spectrophotometric Determination of Titanium Carbide in Carbide Slag
摘 要
碳化渣样品经硫酸和氢氟酸分解,使其中碳化钛相与钛的其它物相分离;然后用硝酸破坏碳化钛,所得溶液中钛(Ⅳ)经过氧化氢显色后,用分光光度法测定其中钛的含量,间接换算成样品中碳化钛含量。为考查方法的精密度,用所提出方法对同一碳化渣样品中碳化钛含量做了8次平行测定,测定结果的相对标准偏差为1.1%。又以另一渣样为基体加入3个质量值(mg)的基准碳化钛,按所提出方法测定后计算其回收率,所得结果在97.4%~101%之间。
Abstract
Sample of carbide slag was dissolved with H2SO4 and HF to separate titanium carbide phase from other titanium phases, then the titanium carbide was decomposed with HNO3. Using H2O2 as chromogenic agent, the Ti(Ⅳ) obtained in the sample solution was determined by spectrophotometry, and the amount of titanium found was converted into content of titanium carbide in the sample. To test precision of the proposed method, content of TiC in a slag sample was determined 8 times in parallel, giving value of RSD of 1.1%. Test for recovery was made by addition of primary standard of TiC at 3 different mass values and values of recovery were calculated from the analytical results obtained which were found in the range of 97.4%-101%.
中图分类号 O652.6
所属栏目 工作简报
基金项目
收稿日期 2012/6/1
修改稿日期
网络出版日期
作者单位点击查看
备注郑小敏(1978-),女,陕西眉县人,高级工程师,主要研究方向为分析化学。
引用该论文: ZHENG Xiao-min. Spectrophotometric Determination of Titanium Carbide in Carbide Slag[J]. Physical Testing and Chemical Analysis part B:Chemical Analysis, 2013, 49(7): 813~815
郑小敏. 分光光度法测定碳化渣中碳化钛含量[J]. 理化检验-化学分册, 2013, 49(7): 813~815
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】彭毅.碳化攀钢高炉渣低温选择氯化的热力学分析[J].钛工业进展, 2005,22(6):45-49.
【2】徐本平,苑广智,黎明,等.钒钛高炉渣中碳化钛测定方法的研究[J].冶金分析, 1990,10(1):35-37.
【3】陈友善.钒钛矿冶金化学物相分析[M].成都:四川人民出版社, 1982.
【4】冯成建,张建树.采用攀钢高炉渣制取碳化钛的试验[J].矿产综合利用, 1997(6):34-41.
【2】徐本平,苑广智,黎明,等.钒钛高炉渣中碳化钛测定方法的研究[J].冶金分析, 1990,10(1):35-37.
【3】陈友善.钒钛矿冶金化学物相分析[M].成都:四川人民出版社, 1982.
【4】冯成建,张建树.采用攀钢高炉渣制取碳化钛的试验[J].矿产综合利用, 1997(6):34-41.
相关信息