S32101双相不锈钢晶间腐蚀试验裂纹判定
Determination on Intergranular Corrosion Crack of S32101Duplex Stainless Steel
摘 要
美标材料ASTM A240UNS S32101双相不锈钢板按照标准ISO 3651—2: 1998中的方法 A(16%硫酸—硫酸铜法, 16%为质量分数)进行晶间腐蚀试验后, 弯曲受检面处出现裂纹, 对空白对比试样实施冷弯后也发现裂纹, 难以判定是否为晶间腐蚀所造成的裂纹缺陷。利用金相方法对裂纹形貌进行观察, 并结合力学性能测试和化学成分分析, 得出弯曲受检面产生的裂纹不是晶间腐蚀所造成的裂纹。
S32101
晶间腐蚀
穿晶裂纹
伸长率
duplex stainless steel
S32101
intergranular corrosion
trans-granular crack
elongation
Abstract
Crack was identified in the bend surface after intergranular corrosion test was done on ASTM A240UNSS32101duplex stainless steel in accordance with test method A(16%sulfuric acid/copper sulfate test)of ISO 3651-2: 1998;and crack was also identified when cold bending was done on the blank comparision specimens.It was hard to determinewhether the crack was caused by intergranular corrosion.The crack appearance was observed through metallographic testmethod, and it was concluded that the crack at the bend surface was not caused by intergranular corrosion.
中图分类号 TG
所属栏目 试验与研究
基金项目
收稿日期 2012/6/7
修改稿日期
网络出版日期
作者单位点击查看
备注李海涛(1986—), 男, 助理工程师。
引用该论文: LI Hai-tao,CHENG Gong. Determination on Intergranular Corrosion Crack of S32101Duplex Stainless Steel[J]. Physical Testing and Chemical Analysis part A:Physical Testing, 2012, 48(11): 721～723
李海涛,程功. S32101双相不锈钢晶间腐蚀试验裂纹判定[J]. 理化检验－物理分册, 2012, 48(11): 721～723
共有人对该论文发表了看法，其中：
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】BS EN ISO 3651—2: 1998 不锈钢耐晶间腐蚀性的测定[S].
【2】马毓华.双相不锈钢的性能与应用[J]. 甘肃科技, 2004, 20(10): 49-51.
【3】ASME Ⅸ—2010 焊接和钎接评定标准[S].
【2】马毓华.双相不锈钢的性能与应用[J]. 甘肃科技, 2004, 20(10): 49-51.
【3】ASME Ⅸ—2010 焊接和钎接评定标准[S].
相关信息
