Automated Ultrasonic Inspection Testing System Based on NC Machine
摘 要
研究了基于数控机床的超声C扫描成像技术。设计试验分析数控机床的运动特性,建立其运动控制的数学模型以实现超声信号采集与C扫描成像的同步。利用RS-232实现数控机床与工控机的串口通信,建立超声自动检测试验平台。通过大量超声C扫描试验表明,该系统具有通用性强、操作方便、开发成本低、检测精度高等优点。
Abstract
A method of ultrasonic C-scan imaging based on NC machine is presented in this paper. An experiment was conducted to analysis the motion characteristics of NC machines, then a model of its motion control was established in order to realize the synchronization of the ultrasonic signal acquisition and C-scan imaging. Then test-bed of automated ultrasonic testing was setup according to RS232. The results of ultrasonic C-scan experiments indicated the validity of the proposed system, which has the advantages of good versatility, easy to operate, low cost and high precision.
中图分类号 TG115.28
所属栏目 仪器研制
基金项目 国家自然科学基金资助项目(51005252);湖南省教育厅科研资助项目(10C0362)
收稿日期 2010/6/24
修改稿日期
网络出版日期
作者单位点击查看
备注胡宏伟(1980-),男,博士,讲师,主要从事检测及信息处理、机械动力与控制方面的研究。
引用该论文: HU Hong-Wei,LI Xiong-Bing,YANG Cheng,NI Pei-Jun,YANG Qian-Qian. Automated Ultrasonic Inspection Testing System Based on NC Machine[J]. Nondestructive Testing, 2011, 33(3): 50~51
胡宏伟,李雄兵,阳程,倪培君,杨茜茜. 基于数控机床的超声自动检测系统[J]. 无损检测, 2011, 33(3): 50~51
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】吴端明.数字化超声检测系统及关键技术研究[D].杭州:浙江大学博士论文,2006:5-6.
【2】黄国兵,张细先.减小数控机床步进电机开环伺服系统误差的方法[J].机械制造与自动化,2002(3):27-28.
【3】蔡启仲,陈初,郑汉梅.基于插补算法的数据拟合与曲线显示[J].仪表技术,2006(5):1-4.
【2】黄国兵,张细先.减小数控机床步进电机开环伺服系统误差的方法[J].机械制造与自动化,2002(3):27-28.
【3】蔡启仲,陈初,郑汉梅.基于插补算法的数据拟合与曲线显示[J].仪表技术,2006(5):1-4.
相关信息