高温高压条件下早期氢腐蚀的超声波检测
Ultrasonic Testing of Early Hydrogen Attack at High Temperature and High Pressure
摘 要
为了对高温高压临氢承压设备的氢腐蚀程度进行评价，探讨了超声波法诊断早期氢腐蚀的可行性。试验将Q345R和20号钢的试块置于450 ℃、18 MPa氢分压的环境中腐蚀18 h，采用波速比法、测厚法、TOFD等超声检测方法进行检测。结果表明，氢蚀后Q345R和20号钢在宏观和微观上均发生了轻微变化，腐蚀程度轻，该条件下的试块仍处于氢腐蚀的孕育期。波速比法难以对该腐蚀条件下的试块进行检测，而测厚法和TOFD法可以对早期氢腐蚀进行有效诊断。
氢腐蚀
超声波检测
High temperature and high pressure
HATA
Ultrasonic testing
Abstract
In order to evaluate the degree of hydrogen corrosion on the pressure equipment at high temperature and high hydrogen pressure, the possibility of diagnosing hydrogen corrosion at early stage by ultrasonic method has been studied. Specimens made of 20 steel and Q345R steel were exposed to hydrogen gas at 450 ℃ with a hydrogen partial pressure 18 MPa for 18 hours，and then its corrosion situations were measured by the velocity ratio, thickness measurement and TOFD methods. The results suggested that it was not easy to detect the hydrogen corrosion by the velocity ratio in this situation if the specimens were corroded lightly, but thickness measurement and TOFD could effectively diagnose the hydrogen corrosion at early stage.
中图分类号 TB559 TG115.28
所属栏目 试验研究
基金项目
收稿日期 2011/10/12
修改稿日期
网络出版日期
作者单位点击查看
备注张伟(1986-)，男，硕士研究生，研究方向为压力容器的无损检测。
引用该论文: ZHANG Wei,GUAN Wei-He,YAN Chang-Zhou. Ultrasonic Testing of Early Hydrogen Attack at High Temperature and High Pressure[J]. Nondestructive Testing, 2013, 35(2): 49～53
张伟,关卫和,阎长周. 高温高压条件下早期氢腐蚀的超声波检测[J]. 无损检测, 2013, 35(2): 49～53
共有人对该论文发表了看法，其中：
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】ANMOL S B, MATHIEU R, KOJI K. Ultrasonic technique for detection of high temperature hydrogen attack［J］. Materials Evaluation,2005(2):110-115.
【2】李丽菲，沈功田.压力容器氢损伤的监测与检测方法［J］.压力容器,2006,23(12):37-41.
【3】谭志捷.钢的氢腐蚀［J］.化工与通用机械,1973(1):23-30.
【4】乔学福.高温高压临氢在用压力容器的氢腐蚀检验［J］.石油化工设备术,2001,22(3):11-21
【5】金术杰，王卫红.氢腐蚀的检测方案［J］.无损探伤,2003,27(5):46-48.
【6】BIRRING A S, BARTLETT M L, KAWANO K. Ultrasonic detection of hydrogen attack in steels［J］. Corrosion,1989,45(3):259-263.
【7】史利冰，关卫和，阎长周，等.压力容器和管道早期氢腐蚀的超声波检测［J］.无损检测,2011,33(7):32-35.
【2】李丽菲，沈功田.压力容器氢损伤的监测与检测方法［J］.压力容器,2006,23(12):37-41.
【3】谭志捷.钢的氢腐蚀［J］.化工与通用机械,1973(1):23-30.
【4】乔学福.高温高压临氢在用压力容器的氢腐蚀检验［J］.石油化工设备术,2001,22(3):11-21
【5】金术杰，王卫红.氢腐蚀的检测方案［J］.无损探伤,2003,27(5):46-48.
【6】BIRRING A S, BARTLETT M L, KAWANO K. Ultrasonic detection of hydrogen attack in steels［J］. Corrosion,1989,45(3):259-263.
【7】史利冰，关卫和，阎长周，等.压力容器和管道早期氢腐蚀的超声波检测［J］.无损检测,2011,33(7):32-35.
相关信息
