SiC颗粒增强铝基复合材料的摩擦磨损性能
Friction and Wear Properties of SiC Particulate Reinforced Aluminum Matrix Composites
摘 要
制备了不同粒度和含量SiC的铝基复合材料,与Santana2000轿车用HFM605型非金属摩擦片材料配成摩擦副,于不同压力和速度条件下在MM-200型摩擦磨损试验机上进行干摩擦试验,研究了其摩擦磨损性能.结果表明：摩擦因数随摩擦压力的增大而下降;比较而言,在高速高压时摩擦因数最低;复合材料中SiC粒度和含量对摩擦因数影响不大;随着SiC粒度减小、含量增大,复合材料的耐磨性能逐渐提高;热处理可以明显提高复合材料的摩擦因数和耐磨性能.
复合材料
摩擦因数
耐磨性能
SiC
composite
friction factor
wear resistance
Abstract
The friction and wear properties of aluminum matrix composites reinforced with SiC particulates with different sizes and contents were studied against HFM605 type nonmetal friction materials under the condition of different friction loads and velocites.The friction factor decreased with increasing load and reached the minimum under high load and high velocity.The size and content of SiC particulates did not show obvious effect on the friction factor.The wear resistance of SiC composite was enhanced with the increase of content and decrease of size of SiC particulates.The friction and wear properties of composites were well improved by heat treatment process.
中图分类号 TB331
所属栏目
基金项目 上海市科委科技攻关项目(015211006)
收稿日期 2005/2/4
修改稿日期 2005/4/24
网络出版日期
作者单位点击查看
备注李俊宪(1979-),男,河南林州人,硕士研究生.
引用该论文: LI Jun-xian,SUN Bao-liang,SHAO Guang-jie. Friction and Wear Properties of SiC Particulate Reinforced Aluminum Matrix Composites[J]. Materials for mechancial engineering, 2006, 30(5): 62～65
李俊宪,孙保良,邵光杰. SiC颗粒增强铝基复合材料的摩擦磨损性能[J]. 机械工程材料, 2006, 30(5): 62～65
被引情况:
【1】陈登斌,霍晓阳,张松利,赵玉涛, "(Al2O3+Al3Zr)p/Al-22Si铝基复合材料的制备及摩擦学性能",机械工程材料 32, 47-50(2008)
【2】王辉,王顺成,郑开宏,王建华,陈学文, "SiC质量分数对SiCp/6061铝基复合材料组织和性能的影响",机械工程材料 40, 52-56(2016)
【3】杨佼源,洪晓露,韦习成,王武荣,欧阳求保,顾海麟,冯奇, "Al2O3连续增强铝基复合材料的干摩擦磨损特性",机械工程材料 39, 81-85(2015)
【4】刘丘林,刘允中,肖文华,康少付,李元元, "喷射成型HGSF01高合金工具钢的摩擦磨损性能",机械工程材料 34, 67-70(2010)
【5】周诗民,余超,祝洪喜,员文杰,邓承继,白晨, "三元碳化物Al4SiC4对无压烧结β-SiC的影响",机械工程材料 39, 45-49(2015)
【6】王开,翟彦博,刘昌明,邹茂华, "离心铸造制备原位初晶硅和Mg2Si颗粒增强铝基骤变复合材料的组织与性能",机械工程材料 34, 47-51(2010)
共有人对该论文发表了看法，其中：
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】Alpas A T,Zhang J.Effect of SiC particulate reinforcement on the dry sliding wear of aluminium-silicon alloys (A356)[J].Wear,1992,155 (1):83-104.
【2】Manish Narayan,Surappa M K,Pramila Bai B N.Dry sliding wear of Al alloy 2024-Al2O3 particle metal matrix composites[J].Wear,1995,181-183:563-570.
【3】Li Xianyao.Wear behaviour and microstructural characterization of worn surfaces and wear debris of a high purity aluminum and an aluminum-silicon alloy and an aluminum-silicon/silicon carbide composite sliding against an M2 steel[D].Canada Ottawa:The University of Manitoba,1999.
【4】Lima S C,Guptaa M,Ren L,et al.The tribological properties of Al-Cu/SiCp metal-matrix composites fabricated using the rheocasting technique[J].Journal of Materials Processing Technology,1999,(89-90):591-596.
【5】Miyajima T,Iwai Y.Effects of reinforcements on sliding wear behavior of aluminum matrix composites[J].Wear,2003,255(1-6):606-616.
【6】许珞萍,邵光杰,李 麟.汽车轻量化用金属材料及其发展动态[J].上海金属,2002,24(3):1-7.
【7】王文龙,吴军华,张国定.铝基复合材料的摩擦磨损性能[J].金属学报,1998,34(11):1179-1182.
【8】黄洁雯.SiCp/ZL102复合材料的耐磨性研究及压铸件制备[D].南京:南京理工大学,2002.
【9】马东辉,张永振,陈 跃,等.速度和压力对SiCp增强铝基复合材料摩擦磨损性能的影响[J].中国表面工程,2004,(1):24-27.
【10】齐海波,樊云昌,丁占来.颗粒增强铝基复合材料在汽车制动盘上的应用[J].河北省科学院学报,2001,18(2):89-92.
【11】马保吉,朱 均.SiCp增强铝基复合材料与Kevlar增强摩擦材料摩擦副摩擦磨损机理研究[J].润滑与密封,2003,(3):36-38.
【2】Manish Narayan,Surappa M K,Pramila Bai B N.Dry sliding wear of Al alloy 2024-Al2O3 particle metal matrix composites[J].Wear,1995,181-183:563-570.
【3】Li Xianyao.Wear behaviour and microstructural characterization of worn surfaces and wear debris of a high purity aluminum and an aluminum-silicon alloy and an aluminum-silicon/silicon carbide composite sliding against an M2 steel[D].Canada Ottawa:The University of Manitoba,1999.
【4】Lima S C,Guptaa M,Ren L,et al.The tribological properties of Al-Cu/SiCp metal-matrix composites fabricated using the rheocasting technique[J].Journal of Materials Processing Technology,1999,(89-90):591-596.
【5】Miyajima T,Iwai Y.Effects of reinforcements on sliding wear behavior of aluminum matrix composites[J].Wear,2003,255(1-6):606-616.
【6】许珞萍,邵光杰,李 麟.汽车轻量化用金属材料及其发展动态[J].上海金属,2002,24(3):1-7.
【7】王文龙,吴军华,张国定.铝基复合材料的摩擦磨损性能[J].金属学报,1998,34(11):1179-1182.
【8】黄洁雯.SiCp/ZL102复合材料的耐磨性研究及压铸件制备[D].南京:南京理工大学,2002.
【9】马东辉,张永振,陈 跃,等.速度和压力对SiCp增强铝基复合材料摩擦磨损性能的影响[J].中国表面工程,2004,(1):24-27.
【10】齐海波,樊云昌,丁占来.颗粒增强铝基复合材料在汽车制动盘上的应用[J].河北省科学院学报,2001,18(2):89-92.
【11】马保吉,朱 均.SiCp增强铝基复合材料与Kevlar增强摩擦材料摩擦副摩擦磨损机理研究[J].润滑与密封,2003,(3):36-38.
相关信息
