Wear and Friction Properties of PTFE-based Composites Filled with MoS2,CdO and FEP
摘 要
用机械共混、冷压成型自由烧结的方法制备了MoS2、CdO和聚全氟乙丙烯填充聚四氟乙烯复合材料;用MM-2000型摩擦磨损试验机测试了在干摩擦条件下该复合材料的摩擦磨损性能;用扫描电镜(SEM)对磨损试样的表面形貌进行观察和分析.结果表明:未添加聚全氟乙丙烯的复合材料其摩擦磨损性能比添加的好;当CdO的体积分数为22.5%,MoS2的体积分数为7.5%时,复合材料的摩擦因数最小,抗磨性强,复合材料的摩擦磨损性能最佳.
Abstract
The composite of polytetrafluroethene(PTFE) filled with MoS2,CdO and FEP was prepared by mechanical mixing,compressing molding and sintering.Under dry friction condition,the wear property of PTFE composites was studied using an MM-2000 wear tester.The frictional surfaces of the composites were examined by means of scanning electron microscopy (SEM).The wear and friction properties of the PTFE composites without FEP are better than those with FEP.When CdO is 22.5vol% and MoS2 is 7.5vol%,the friction and wear properties of PTFE composites are the best.
中图分类号 TB333
所属栏目
基金项目 国家自然科学基金资助项目(50432020)
收稿日期 2005/12/28
修改稿日期 2006/3/14
网络出版日期
作者单位点击查看
备注曹翠玲(1978-),女,河南开封人,硕士研究生.
引用该论文: CAO Cui-ling,YAN Feng-yuan. Wear and Friction Properties of PTFE-based Composites Filled with MoS2,CdO and FEP[J]. Materials for mechancial engineering, 2007, 31(1): 47~49
曹翠玲,阎逢元. MoS2、CdO及聚全氟乙丙烯填充改性聚四氟乙烯[J]. 机械工程材料, 2007, 31(1): 47~49
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】张招柱,曹佩弦,王坤,等.PTFE 复合材料的摩擦学性能及力学性能[J].高分子材料科学与工程,2005,25(2):189-192.
【2】李飞,胡克鳌,阎逢元,等.纳米ZnO填充的PTFE基复合材料摩擦学性能研究[J].润滑与密封,2000,6:37-39.
【3】黄丽,孙正滨.PTFE复合材料力学与摩擦性能研究[J].复合材料学报,2000,17(4):54-57.
【4】周坤粦,曹伟民,张勇,等.氮化钛超微细粉PTFE基复合材料的摩擦性能[J].科学通报,1997,42(16):1733-1735.
【5】乐启发,徐下忠,李信.POM/改性PTFE合金的研究[J].工程塑料应用,2001,29(7):6-8.
【6】唐炜,朱宝亮,刘家浚,等.液晶微纤原位增强PTFE复合材料抗磨性能与磨损机理[J].摩擦学学报,2000,20(1):10-13.
【7】Gregory S W,Freudenberg K D,Bhimaraj P,et al.A study on the friction and wear behavior of PTFE filled with alumina nanoparticles[J].Wear,2003,254:573-580.
【8】Khedkar J,Negulescu I,Meletis EI.Sliding wear behavior of PTFE composites[J].Wear,2002,252:361-369.
【9】Theiler G,Hübner W,Gradt T,et al.Friction and wear of PTFE composites at cryogenic temperatures[J].Tribology International,2002,35:449-458.
【10】何春霞,王耀华.Al2O3纤维填充PTFE复合材料摩擦磨损性能分析[J].机械工程材料,2002,26(12):35-38.
【11】Yan Feng-yuan,Xue Qun-ji.Study of fretting wer behaviors of FEP[J].Journal of Applied Polymer Science,1998,67:1119-1125.
【12】张招柱,薛群基,刘维民,等.几种金属氧化物填充聚四氟乙烯复合材料在干摩擦条件下的摩擦磨损性[J].摩擦学学报,1997,17(1):45-52.
【2】李飞,胡克鳌,阎逢元,等.纳米ZnO填充的PTFE基复合材料摩擦学性能研究[J].润滑与密封,2000,6:37-39.
【3】黄丽,孙正滨.PTFE复合材料力学与摩擦性能研究[J].复合材料学报,2000,17(4):54-57.
【4】周坤粦,曹伟民,张勇,等.氮化钛超微细粉PTFE基复合材料的摩擦性能[J].科学通报,1997,42(16):1733-1735.
【5】乐启发,徐下忠,李信.POM/改性PTFE合金的研究[J].工程塑料应用,2001,29(7):6-8.
【6】唐炜,朱宝亮,刘家浚,等.液晶微纤原位增强PTFE复合材料抗磨性能与磨损机理[J].摩擦学学报,2000,20(1):10-13.
【7】Gregory S W,Freudenberg K D,Bhimaraj P,et al.A study on the friction and wear behavior of PTFE filled with alumina nanoparticles[J].Wear,2003,254:573-580.
【8】Khedkar J,Negulescu I,Meletis EI.Sliding wear behavior of PTFE composites[J].Wear,2002,252:361-369.
【9】Theiler G,Hübner W,Gradt T,et al.Friction and wear of PTFE composites at cryogenic temperatures[J].Tribology International,2002,35:449-458.
【10】何春霞,王耀华.Al2O3纤维填充PTFE复合材料摩擦磨损性能分析[J].机械工程材料,2002,26(12):35-38.
【11】Yan Feng-yuan,Xue Qun-ji.Study of fretting wer behaviors of FEP[J].Journal of Applied Polymer Science,1998,67:1119-1125.
【12】张招柱,薛群基,刘维民,等.几种金属氧化物填充聚四氟乙烯复合材料在干摩擦条件下的摩擦磨损性[J].摩擦学学报,1997,17(1):45-52.
相关信息