循环水泵泵轴联轴器螺栓断裂分析
Fracture Analysis of Coupling Bolt of Pump Spindle for Water Circulating Pump
摘 要
采用化学成分分析、室温力学性能测试以及金相检验对某电厂材料为35CrMo钢的循环水泵泵轴联轴器螺栓的断裂原因进行了分析。结果表明：由于该螺栓在热加工成型后未按要求进行调质处理,导致其硬度和强度偏低,加上螺栓头部形状不规则以及螺栓头部与螺杆连接部位没有过渡圆弧造成应力集中,使螺栓在循环水泵运行过程中泵轴轴系的周期性振动下发生疲劳断裂。
疲劳断裂
调质处理
应力集中
bolt
fatigue fracture
quenching and tempering treatment
stress concentration
Abstract
The fracture reason of a coupling bolt of pump spindle for water circulating pump with material of 35CrMo steel was analyzed by means of chemical compositions analysis, mechanical properties testing at room temperature and metallographic examination. The results show that the wrong specification of heat treatment after the hot forming process which caused the hardness and strength of the bolt reduced, irregular shape of the bolt head and the stress concentration because of no transition at the joints of the bolt head and screw arbor coacted and resulted in the fatigue fracture of the bolt under the periodic vibration of the shaft in the course of pump operation.
中图分类号 TG142
所属栏目 质量控制与失效分析
基金项目
收稿日期 2009/8/9
修改稿日期
网络出版日期
作者单位点击查看
备注崔正强(1980-),男,工程师，硕士。
引用该论文: CUI Zheng-qiang,WU Zhi-ying,WANG De-jian,LI Qiang. Fracture Analysis of Coupling Bolt of Pump Spindle for Water Circulating Pump[J]. Physical Testing and Chemical Analysis part A:Physical Testing, 2010, 46(6): 406～408
崔正强,吾之英,汪德健,李 强. 循环水泵泵轴联轴器螺栓断裂分析[J]. 理化检验－物理分册, 2010, 46(6): 406～408
共有人对该论文发表了看法，其中：
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】任颂赞,张静如,陈质如,等.钢铁金相图谱[M].上海：上海科学技术文献出版社,2003．
【2】钟群鹏,田永江.失效分析基础[M].北京：机械工业出版社,1991．
【3】王国阳,徐卫平,张宝奇，等.船用柴油机连接螺栓断裂失效分析[J]机械工程材料,2006,30(4)：92-94．
【2】钟群鹏,田永江.失效分析基础[M].北京：机械工业出版社,1991．
【3】王国阳,徐卫平,张宝奇，等.船用柴油机连接螺栓断裂失效分析[J]机械工程材料,2006,30(4)：92-94．
相关信息
