PREPARATION METHOD OF CADMIUM COATING METALLOGRAPHIC SPECIMEN
摘 要
采用常规的金相制样法制备不锈钢基体的镀镉层试样极易造成镀层凹陷倒边,使试样的镀层在100倍光学显微镜下呈现黑色。实践证明,在制备此类镀镉层试样时,在镀嵌、夹具夹持、磨制及抛光等环节掌握好技巧就能避免出现镀镉层凹陷现象,可满足对镀镉层厚度测量的要求。
Abstract
Method of preparing cadmium coating metallographic specimen dopted the conventional metallognaphic preparation method for cadmium coating on the surface of the stainless steel matrix,it can make the cadmium coating sunken and make it become black.Pracietice shows,if you master the method and skill in the process of preparing specimen,such as specimen inlay,grippping,grinding and polishing,you can prevent the cadmiun coating sunken and measure the thickness of the cadmiun coating perfeetly.
中图分类号 TG115.21+1.2
所属栏目 实践经验
基金项目
收稿日期 2007/10/28
修改稿日期
网络出版日期
作者单位点击查看
备注郭海霞(1981-),女,助理工程师。
引用该论文: GUO Hai-xia,YANG Zhi-yong. PREPARATION METHOD OF CADMIUM COATING METALLOGRAPHIC SPECIMEN[J]. Physical Testing and Chemical Analysis part A:Physical Testing, 2008, 44(6): 314~315
郭海霞,杨之勇. 镀镉层试样的金相制备方法[J]. 理化检验-物理分册, 2008, 44(6): 314~315
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
相关信息