Designing and Compiling X-Ray Inspection Procedures Based on VC Program
摘 要
为使工业射线检测工作者能快速准确地编制出检测工艺, 提出了计算机程序辅助编制检测工艺的方法, 并给出了具体的程序。经过多次的测试及现场实际检测应用, 证实了编制的辅助工艺程序提供的数据准确, 详实。为射线检测工艺编制人员解决了大量复杂的计算及查表问题, 节约人力物力, 同时该方法有效提高了工艺编制的效率及准确性和精确性, 对实际射线检测工作具有一定的指导意义。
Abstract
In order to enable radiographic inspector to compile the inspection procedures and give instruction more effectively and accurately, this article proposed computer aided inspection procedures compiling method and showed the detailed program. The results of many times of tests and field application proved the accuracy of the data provided by the program. This method reduces the complex calculation and table look up work for radiographic inspector, so a lot of human resource and material resource is saved. This method increases the efficiency and accuracy of procedures compilation and has definite guiding significance.
中图分类号 TG115.28
所属栏目 实践经验
基金项目
收稿日期 2009/6/9
修改稿日期
网络出版日期
作者单位点击查看
备注刘长福(1977-), 男, 工程师, 主要从事无损检测工作。
引用该论文: LIU Chang-Fu,LI Zhong-Wei,JING Shang-Qian. Designing and Compiling X-Ray Inspection Procedures Based on VC Program[J]. Nondestructive Testing, 2010, 32(6): 454~456
刘长福,李中伟,敬尚前. 基于VC程序的射线检测工艺编制[J]. 无损检测, 2010, 32(6): 454~456
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】强天鹏.射线检测[M].昆明: 云南科技出版社出版, 2001.
【2】JB/T 4730.2—2005 《承压设备无损检测》射线检测[S].
【2】JB/T 4730.2—2005 《承压设备无损检测》射线检测[S].
相关信息