The Three-Dimensional CT Detection of Aero-Engine Turbine Blade
摘 要
介绍了三维CT(计算机层析成像)成像的原理,给出了针对航空发动机涡轮叶片这种异形结构的多模式重建算法,进行了航空发动机涡轮叶片的三维CT检测试验。结果表明:三维工业CT技术能从多个方位表征叶片内部的裂纹、气孔、夹杂等缺陷,比胶片射线照相更加直观、全面,值得推广。
Abstract
An introduction is made on the theory of three-dimensional CT imaging, and a reconstruction algorithm for the abnormal structure such as aero-engine turbine blade is given. Researches on the three-dimensional CT gas turbine engine test were carried out. Results show that the 3D industrial CT technology can characterize the internal cracks, such as porosity, inclusions and other defects from multiple azimuths, resulting in more direct and more complete viewing of the defects than film radiography, and is worthy of promotion.
中图分类号 TG115.28 DOI 10.11973/wsjc201708008
所属栏目 试验研究
基金项目
收稿日期 2017/1/3
修改稿日期
网络出版日期
作者单位点击查看
备注张祥春(1981-),男,高级工程师,主要从事射线检测及工业CT检测技术研究
引用该论文: ZHANG Xiangchun,ZHOU Yanxian,LIU An,WANG Juntao. The Three-Dimensional CT Detection of Aero-Engine Turbine Blade[J]. Nondestructive Testing, 2017, 39(8): 34~36
张祥春,周言贤,刘安,王俊涛. 航空发动机涡轮叶片的三维CT检测[J]. 无损检测, 2017, 39(8): 34~36
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】陶春虎,刘新灵.航空发动机材料和工艺的安全性评估[J].失效分析与预防,2007,2(4):14-20.
【2】张祥春,张鹭,王俊涛. 工业CT技术在航空发动机单晶叶片壁厚测量中的应用[J].无损检测,2015,37(2):20-22.
【3】李世雄.层析成象中的数学方法问题及其应用进展[J].地球物理学进展,1991,6(3):51-60.
【4】彭光含.连续谱X射线在ICT中的能谱硬化与散射修正[D].重庆:重庆大学,2006.
【2】张祥春,张鹭,王俊涛. 工业CT技术在航空发动机单晶叶片壁厚测量中的应用[J].无损检测,2015,37(2):20-22.
【3】李世雄.层析成象中的数学方法问题及其应用进展[J].地球物理学进展,1991,6(3):51-60.
【4】彭光含.连续谱X射线在ICT中的能谱硬化与散射修正[D].重庆:重庆大学,2006.
相关信息