Cause Analysis on Significant Decrease of Impact Toughness of Nitronic 50 Stainless Steel at Cryogenic Temperature
摘 要
针对低温风洞运动机构用Nitronic 50奥氏体不锈钢在复检中出现低温冲击吸收能量显著偏低的现象,对该批次不锈钢和参考样品分别取样,进行了化学成分、金相、扫描电镜以及能谱等分析。结果表明:该批次Nitronic 50不锈钢中存在大量短棒状的AlN脆性夹杂物,是导致其低温冲击韧性大幅度降低的主要原因;材料晶粒尺寸偏大且存在混晶现象也降低了其冲击韧性。
Abstract
Regarding to the obvious low impact absorption energy of Nitronic 50 austenitic stainless steel used in the movement mechanism of cryogenic wind tunnel at cryogenic temperature during reinspection, a series of testing methods were adopted on the specimens of raw material and reference sample, such as chemical composition analysis, metallographic analysis, scanning electron microscope and energy spectrum analysis, and so on. The results show that numerous short rod-like AlN brittle inclusions existing in this batch of Nitronic 50 stainless steel were the main reason for the significant decrease of the impact toughness at cryogenic temperature. The coarse grain and the mischcrystal in the material also reduced the impact toughness.
中图分类号 TG111.91 DOI 10.11973/lhjy-wl201710012
所属栏目 质量控制与失效分析
基金项目
收稿日期 2016/9/14
修改稿日期
网络出版日期
作者单位点击查看
备注孙德文(1986-),男,工程师,硕士,主要从事风洞结构设计及分析工作,resistwater@163.com
引用该论文: SUN Dewen,CHEN Wanhua,ZHU Changjiang,MOU Zhichao. Cause Analysis on Significant Decrease of Impact Toughness of Nitronic 50 Stainless Steel at Cryogenic Temperature[J]. Physical Testing and Chemical Analysis part A:Physical Testing, 2017, 53(10): 750~753
孙德文,陈万华,祝长江,牟志超. Nitronic 50不锈钢低温冲击韧性大幅降低原因分析[J]. 理化检验-物理分册, 2017, 53(10): 750~753
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】廖达雄,黄知龙,陈振华,等.大型低温高雷诺数风洞及其关键技术综述[J].实验流体力学,2014,28(2):1-6,20.
【2】杨汗青,潘亚东,吴惠芳.天然气工程中低温钢的选用[J].天然气与石油,2008,26(5):22-25,72.
【3】DENHARD E F. High-strength corrosion-resistant stainless steel:3592634[P].1971-06-13.
【4】GAUGH R R, PERRY D C.New stainless steel for the CPI[J].Chemical Engineering,1972,79(22):84-90.
【5】RITTER A M, HENRY M F, SAVAGE W F. High temperature phase chemistries and solidification mode prediction in nitrogen-strengthened austenitic stainless steels[J].Metallurgical Transactions:A,1984,15(7):1339-1351.
【6】BROMLEY A V, PARKER R H.Sources of trace elements in primary raw materials used in production of superalloys[J].Metals Technology,1984,11(1):419-427.
【7】HOLT R T,WALLACE W.Impurities and trace elements in nickel-base superalloys[J].International Metals Reviews,1976,21(1):1-24.
【8】莫立华,朱永新,高杰,等.XM-19不锈钢锻造开裂的研究[J].理化检验-物理分册,1999,35(1):12-14,24.
【9】张全新.3Cr20Ni11Mo2PB钢气阀门断裂原因分析[J].理化检验-物理分册,2013,49(2):127-129.
【2】杨汗青,潘亚东,吴惠芳.天然气工程中低温钢的选用[J].天然气与石油,2008,26(5):22-25,72.
【3】DENHARD E F. High-strength corrosion-resistant stainless steel:3592634[P].1971-06-13.
【4】GAUGH R R, PERRY D C.New stainless steel for the CPI[J].Chemical Engineering,1972,79(22):84-90.
【5】RITTER A M, HENRY M F, SAVAGE W F. High temperature phase chemistries and solidification mode prediction in nitrogen-strengthened austenitic stainless steels[J].Metallurgical Transactions:A,1984,15(7):1339-1351.
【6】BROMLEY A V, PARKER R H.Sources of trace elements in primary raw materials used in production of superalloys[J].Metals Technology,1984,11(1):419-427.
【7】HOLT R T,WALLACE W.Impurities and trace elements in nickel-base superalloys[J].International Metals Reviews,1976,21(1):1-24.
【8】莫立华,朱永新,高杰,等.XM-19不锈钢锻造开裂的研究[J].理化检验-物理分册,1999,35(1):12-14,24.
【9】张全新.3Cr20Ni11Mo2PB钢气阀门断裂原因分析[J].理化检验-物理分册,2013,49(2):127-129.
相关信息