搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
P92钢在内压和拉伸组合加载下的蠕变行为
          
Creep Behavior of P92 Steel Subjected to Combination Loading of Inner Pressure and Tensile

摘    要
采用内压和拉伸组合加载方法,在650℃下对P92钢管状试样进行了不同多轴度的蠕变试验并利用改进的Kachanov-Robatnov蠕变模型对其蠕变行为进行有限元模拟,观察了断口形貌和显微组织,分析了多轴度对P92钢应力分布和损伤发展的影响。结果表明:在内压和拉伸组合加载下,当外壁等效应力相同时,多轴度越大,P92钢的蠕变寿命越短;多轴度对P92钢蠕变孔洞的生长具有促进作用;改进的Kachanov-Robatnov蠕变模型可以准确地描述P92钢的蠕变行为;在蠕变过程中,多轴度影响应力的分布,进而影响损伤的分布,多轴度大的位置其损伤程度也大。
标    签 P92钢   多轴度   蠕变行为   有限元模拟   P92 steel   multiaxiality   creep behavior   finite element simulation  
 
Abstract
Different multiaxial creep experiments were conducted on P92 steel tube samples under combination loading of inner pressure and tensile at 650℃ and the creep behavior was simulated by modified Kachanov-Robatnov creep model. The fracture morphology and microstructure were observed and the influence of multiaxiality on stress distribution and damage evolution of P92 steel was analyzed. The results show that the higher the multiaxiality, the shorter the creep lifetime of P92 steel subjected to combination loading of inner pressure and tensile was when the equivalent stress on the outside of tube was the same. The modified Kachanov-Robatnov creep model could describe the creep behavior of P92 steel accurately. Multiaxiality influenced the stress distribution, and then affected the distribution of damage during creep. The position with the largest multiaxiality had the largest damage.

中图分类号 TG113.25   DOI 10.11973/jxgccl201803014

 
  中国光学期刊网论文下载说明


所属栏目 物理模拟与数值模拟

基金项目 国家自然科学基金资助项目(51134016);中央高校基本科研业务费专项资金资助项目(2016XS28)

收稿日期 2017/11/23

修改稿日期 2018/2/1

网络出版日期

作者单位点击查看

备注蓝翔(1988-),男,四川内江人,博士研究生

引用该论文: LAN Xiang,XU Hong,LI Mengyang,NI Yongzhong. Creep Behavior of P92 Steel Subjected to Combination Loading of Inner Pressure and Tensile[J]. Materials for mechancial engineering, 2018, 42(3): 74~79
蓝翔,徐鸿,李梦阳,倪永中. P92钢在内压和拉伸组合加载下的蠕变行为[J]. 机械工程材料, 2018, 42(3): 74~79


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】耿鲁阳, 郭晓峰, 巩建鸣,等. 国产和进口P92耐热钢显微组织、拉伸和蠕变性能的对比[J]. 机械工程材料, 2014, 38(1):68-73.
 
【2】姚华堂, 轩福贞, 沈树芳, 等. 高温材料的多轴蠕变试验方法[J]. 机械工程材料, 2008, 32(1): 5-9.
 
【3】JIANG Y P, GUO W L, YUE Z F. On the study of the creep damage development in circumferential notch specimens[J]. Computational Materials Science, 2007,38(4):653-659.
 
【4】NI Y Z, LAN X, XU H, et al. Finite element analysis and experimental research on notched strengthening effect of P92 steel[J]. Materials at High Temperatures, 2014, 31(2):185-190.
 
【5】GOYAL S, LAHA K. Creep life prediction of 9Cr-1Mo steel under multiaxial state of stress[J]. Materials Science & Engineering A, 2014, 615:348-360.
 
【6】常愿,徐鸿,蓝翔. P92钢多轴蠕变本构模型的建立及验证[J]. 机械工程材料, 2017, 41(2): 112-118.
 
【7】WANG L Q, WANG J G, WANG H Y, et al. Interaction of fatigue and creep of GH33 under multi-axial stress at high temperature[J]. Journal of University of Science and Technology Beijing, 2003, 10(2):79-80.
 
【8】SELIGER P, GAMPE U. Life assessment of creep exposed components, new challenges for condition monitoring of 9Cr steels[J]. OMMI, 2002, 1(2): 2-14.
 
【9】YAO H T, XUAN F Z, WANG Z D, et al. A review of creep analysis and design under multi-axial stress states[J]. Nuclear Engineering and Design 2007, 237(18):1969-1986.
 
【10】HYDE T H, XIA L, BECKER A A. Prediction of creep failure in aeroengine materials under multi-axial stress states[J]. International Journal of Mechanical Sciences, 1996, 38(4):385-403.
 
【11】GOODALL I W, SKELTON R P. The importance of multiaxial stress in creep deformation and rupture[J]. Fatigue & Fracture of Engineering Materials & Structures, 2004, 27(4): 267-272.
 
【12】RABOTNOV Y N.Creep problems in structural members[M].Amsterdam:North-Holland Publishing Company,1969.
 
【13】倪永中, 蓝翔. 一种用于P92钢寿命预测的蠕变模型研究[J]. 应用力学学报, 2014(6): 978-982.
 
【14】WEBSTER G A, NIKBIN K M, BIGLARI F. Finite element analysis of notched bar skeletal point stresses and dimension changes due to creep[J]. Fatigue & Fracture of Engineering Materials & Structures, 2004, 27(4):297-303.
 
相关信息
   标题 相关频次
 P92钢多轴蠕变本构模型的建立及验证
 6
 壁厚不均对平面内弯矩作用下P92钢管弯头蠕变寿命的影响
 6
 Lamb波损伤散射及损伤成像的模拟
 4
 2024铝合金随机多弹丸喷丸后残余应力场的有限元模拟
 2
 20CrMnTi齿轮钢棒材控轧控冷工艺的优化
 2
 2124铝合金超厚板热轧过程温度场的数值模拟
 2
 22MnB5钢制轿车后桥横梁热冲压成形的有限元模拟
 2
 6061-T6铝合金MIG焊接头微区拉伸性能表征及接头拉伸性能的有限元仿真
 2
 6063铝合金在不同应力状态下的变形及损伤行为
 2
 650 ℃等温时效过程中P92钢沉淀相的转变规律
 2
 CR1500HF热成形钢U形件不同位置的高速拉伸性能及其有限元模拟
 2
 DD3镍基单晶高温合金喷丸强化后残余应力的有限元模拟
 2
 GCr15钢奥氏体晶粒长大的有限元模拟
 2
 Haynes 282镍基合金在600~700℃超临界水中的氧化特性
 2
 mini轧机轧制AISI1015钢轧件温升和应变的有限元模拟
 2
 P91和P92马氏体耐热钢焊缝中的黑线
 2
 P92钢的高温低周疲劳行为及寿命预测
 2
 P92钢的过冷奥氏体等温转变曲线及显微组织
 2
 P92钢的蠕变-疲劳损伤行为及蠕变-疲劳损伤本构模型的建立
 2
 P92钢多层多道焊接接头残余应力的有限元模拟
 2
 P92钢焊接接头超声波检测缺陷的分析
 2
 P92钢焊接接头性能及其焊接材料研究进展
 2
 P92钢在蠕变-疲劳交互作用下的初始循环特性
 2
 P92钢中Laves相在时效过程中的形成及粗化规律
 2
 PC+ABS工程塑料合金薄壁制件注塑工艺参数的优化
 2
 PCBN刀具高速切削镍基高温合金GH4169的有限元模拟
 2
 Q235钢薄板单点增量成形延性破损的有限元模拟
 2
 SiCp/Al复合材料铣削有限元模拟的可行性
 2
 TC4钛合金薄板激光焊接变形的有限元模拟
 2
 TiB2/Al复合材料喷丸后微区残余应力的有限元模拟
 2