采用脉冲激光沉积技术在云母柔性衬底上沉积0.1HoMnO₃-0.9BiFeO₃薄膜，研究了薄膜的晶体结构、表面形貌、弯曲服役特性、铁电和介电性能以及输运特性。结果表明：BiFeO₃沿（012）和（104）晶面取向生长，结晶良好；薄膜表面光滑，均方根表面粗糙度为6.7 nm，连续弯曲平整10 000次后表面无细微裂纹；薄膜具有良好的微观压电性，且呈现出一定的向上自发极化特性；薄膜的饱和极化强度和剩余极化强度分别为68，61 μC·cm^-2，弯曲至曲率半径为2.2 mm时的极化强度变化不大，连续弯曲平整10 000次后则有所降低，平整状态和弯曲状态下的介电性能相差较小；薄膜的激活能为0.42 eV，低于纯BiFeO₃薄膜的，其载流子输运能力有所增强。

Thin film of 0.1HoMnO₃-0.9BiFeO₃ was deposited on flexible mica substrate by pulsed laser deposition. The crystal structure, surface appearance, bending service characteristic, ferroelectric and dielectric properties and carriage property of the film were studied. The results show that BiFeO₃ grew along the (012) and (104) crystal planes and had good crystallization. The film presented a smooth surface with root mean square surface roughness of 6.7 nm. After continuously bending and flatting for 10 000 times, the film surface showed no microcracks. The film illustrated a good micro piezoelectricity and a certain upward spontaneous polarization. The saturated and remanent polarization of the film were 68, 61 μC·cm^-2, respectively. The polarization changed little after bending to curvature radius of 2.2 mm, whereas decreased slightly after continuously bending and flatting for 10 000 times; the dielectric properties in flatting and bending states had little difference. The activation energy of the film was 0.42 eV, which was lower than that of pure BiFeO₃ film, indicating an increased carrier transport capacity.