Reasons for Corrosion Perforation of GIS Wall Bushing and Improvement Suggestions
摘 要
某变电站GIS(气体绝缘开关设备)穿墙套筒发生腐蚀穿孔导致SF6泄漏。通过腐蚀环境分析及腐蚀产物检测,结合腐蚀发生的部位、形态,对其失效原因进行了分析。结果表明:防火包渗出的浸蚀性阴离子是诱导筒体发生电化学腐蚀的主要原因,铝合金钝化膜遭到破坏后,酸性玻璃胶释放出的醋酸使GIS穿墙套筒在酸性环境中形成钝化-活性腐蚀电池,最终发展成为严重的孔蚀。结合以往事故经验,认为GIS穿墙套筒的施工工艺在一定条件下可能导致电化学腐蚀,并依此提出防范措施。
Abstract
Corrosion perforation of a GIS (gas insulated switchgear) wall bushing in a substation resulted in SF6 leakage. The failure reasons for the GIS wall bushing were investigated through corrosion environment analysis and corrosion product detection combined with the location and morphology of corrosion. The results that the corrosive anion exuded from fire-proof package was the main cause of inducing electrochemical corrosion of the wall bushing. After the passivation film of aluminum alloy was destroyed, a passive-active corrosive cell formed on the surface of GIS wall bushing because of acidic environment constructed by acetic acid which was released by acidic glass gel, and then the corrosive cell finally became a serious pitting. According to the experience of past accidents, it was concluded that the process of GIS wall bushing could cause electrochemical corrosion under certain conditions, and some preventive measures were proposed.
中图分类号 TG172 DOI 10.11973/fsyfh-202002014
所属栏目 失效分析
基金项目
收稿日期 2018/4/12
修改稿日期
网络出版日期
作者单位点击查看
引用该论文: LIANG Qinqin,LIN Chaofu,ZHANG Longfei,LUO Zongchang. Reasons for Corrosion Perforation of GIS Wall Bushing and Improvement Suggestions[J]. Corrosion & Protection, 2020, 41(2): 74
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】孙改兰,高研. GIS设备漏气缺陷及防范措施[J]. 河南电力,2014(3):29-31.
【2】结田康一,李梦. 土壤溶液和雨水中氯、溴、碘的活化分析[J]. 原子能农业译丛, 1982(3):56-62.
【3】朱祖芳. 铝合金阳极氧化与表面处理技术[M]. 北京:化学工业出版社,2004.
【4】杨熙珍, 杨武. 金属腐蚀电化学热力学:电位-PH图及其应用[M]. 北京:化学工业出版社, 1991.
【5】陈俐侃, 罗苹, 曾晖. 注意室内装修中又一空气污染物:乙酸气体[J]. 中国民康医学, 2010, 22(16):2146-2147.
【6】陈灏. GIS外壳环流和暂态地电位升高的研究[D]. 北京:北京交通大学, 2011.
【7】张猛,吴雪峰,王建西. GIS铝合金材质壳体交流感应电化学腐蚀现象研究[J]. 高压电器,2014,50(9):1-5.
【8】丁斌, 徐耀良, 杨宁, 等. 大电流封闭母线磁-流-热场耦合有限元分析[J]. 高压电器, 2010, 46(8):31-34.
【9】ZAID B, SAIDI D, BENZAID A, et al. Effects of pH and chloride concentration on pitting corrosion of AA6061 aluminum alloy[J]. Corrosion Science, 2008, 50(7):1841-1847.
【10】马腾, 王振尧, 韩薇. 铝和铝合金的大气腐蚀[J]. 腐蚀科学与防护技术, 2004, 16(3):155-161.
【2】结田康一,李梦. 土壤溶液和雨水中氯、溴、碘的活化分析[J]. 原子能农业译丛, 1982(3):56-62.
【3】朱祖芳. 铝合金阳极氧化与表面处理技术[M]. 北京:化学工业出版社,2004.
【4】杨熙珍, 杨武. 金属腐蚀电化学热力学:电位-PH图及其应用[M]. 北京:化学工业出版社, 1991.
【5】陈俐侃, 罗苹, 曾晖. 注意室内装修中又一空气污染物:乙酸气体[J]. 中国民康医学, 2010, 22(16):2146-2147.
【6】陈灏. GIS外壳环流和暂态地电位升高的研究[D]. 北京:北京交通大学, 2011.
【7】张猛,吴雪峰,王建西. GIS铝合金材质壳体交流感应电化学腐蚀现象研究[J]. 高压电器,2014,50(9):1-5.
【8】丁斌, 徐耀良, 杨宁, 等. 大电流封闭母线磁-流-热场耦合有限元分析[J]. 高压电器, 2010, 46(8):31-34.
【9】ZAID B, SAIDI D, BENZAID A, et al. Effects of pH and chloride concentration on pitting corrosion of AA6061 aluminum alloy[J]. Corrosion Science, 2008, 50(7):1841-1847.
【10】马腾, 王振尧, 韩薇. 铝和铝合金的大气腐蚀[J]. 腐蚀科学与防护技术, 2004, 16(3):155-161.
相关信息