High precision measurement technology of small diameter pipe
摘 要
建立了一套基于离散信号周期分离与统计的小管径管材外形尺寸测量方法,在不苛求机械安装精度的前提下,提高核级小管径管材外形尺寸的测量精度。并通过自研的TESC-200管材高速检测系统在4 000 r·min-1的条件下进行试验,验证了该方法的有效性。
Abstract
When the outer diameter of the small diameter pipe is measured by the double ultrasonic probe immersed in water, the axis of the probe group cannot be completely coincident, and the imeasurable deviation of the rotation center of the probe group and the axis of the tube to be detected shall result in the error of the outside diameter being beyond the nuclear level of small diameter pipe measurement requirements. To this end, the discrete signal cycle separation and statistics of small pipe diameter measurement method were established, which shall improve the nuclear grade small diameter pipe diameter measurement accuracy without demanding mechanical installation accuracy. And the validity of the method was verified by the self-developed TESC-200 pipe high-speed detection system under the condition of 4 000 r·min-1.
中图分类号 TG115.28 DOI 10.11973/wsjc202012010
所属栏目 试验研究
基金项目
收稿日期 2020/6/21
修改稿日期
网络出版日期
作者单位点击查看
备注张益成(1984-),男,博士,高级工程师,主要从事无损检测技术研究工作
引用该论文: ZHANG Yicheng,NIE Yong,CAI Jiafan. High precision measurement technology of small diameter pipe[J]. Nondestructive Testing, 2020, 42(12): 44~47
张益成,聂勇,蔡家藩. 小管径管材外形尺寸的高精度测量技术[J]. 无损检测, 2020, 42(12): 44~47
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】李晓丽, 陶宁.基于超声方法的聚乙烯管材厚度和直径测量[J]. 无损检测,2008,30(9):608-609.
【2】郑平子. 小管径薄壁管超声探伤和尺寸测量系统的研究[J]. 核工业自动化, 1998(4):24-31.
【2】郑平子. 小管径薄壁管超声探伤和尺寸测量系统的研究[J]. 核工业自动化, 1998(4):24-31.
相关信息