Application of microfocus industrial CT controlling in improving the coating process of charge head for bridge wire electric ignition
摘 要
通过对火工品点火药头桥丝区涂覆点火药工艺的技术进行研究,发现采用一定浓度的点火药涂覆药头时,桥丝周围会出现缩孔,缩孔直径约为200 μm,该缩孔可能对火工品点火药头发火的可靠性产生影响。采用微焦点CT成像检测技术对涂覆药头形成的缩孔进行检测,另外,在采用微焦点CT成像检测技术的基础上,改变点火药调制浓度,改善药头涂覆工艺,能够有效避免涂覆药头形成缩孔而影响产品发火的可靠性。
Abstract
Through the research on the technology of coating the ignition powder in the bridge wire area of the ignition powder head, it is found that when a certain concentration of ignition powder is used to coat the powder head, shrinkage holes will appear around the bridge wire, and the diameter of the shrinkage hole is 200 μm. Shrinkage cavities may have an impact on the reliability of the ignition of the pyrotechnic charge. The micro-focus CT imaging technology is used to detect the shrinkage cavity formed by the coating head. In addition, on the basis of the micro-focus CT imaging detection, the modulation concentration of the ignition powder is changed to improve the coating process of the head, that method can effectively avoid the head forms shrinkage holes which affects the ignition reliability of the product.
中图分类号 TG115.28 DOI 10.11973/wsjc202210017
所属栏目 实践经验
基金项目
收稿日期 2022/2/16
修改稿日期
网络出版日期
作者单位点击查看
备注张海东(1983-),男,硕士,工程师,主要从事军用火工品的无损检测工作
引用该论文: ZHANG Haidong,WANG Guoqiang,ZHOU Hanbin,WANG Qiran,LI Rong. Application of microfocus industrial CT controlling in improving the coating process of charge head for bridge wire electric ignition[J]. Nondestructive Testing, 2022, 44(10): 74~77
张海东,王国强,周涵彬,王启然,李蓉. 微焦点工业CT成像检测在桥丝电点火药头涂覆工艺控制中的应用[J]. 无损检测, 2022, 44(10): 74~77
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
参考文献
【1】陈守文, 成一, 张赞峰, 等. 涂覆式桥丝电点火头的研究[J].火工品, 2002(3):15-17.
【2】王鹏, 杜志明. 桥丝式电火工品热点火理论[J]. 火工品, 2007(4):26-30.
【2】王鹏, 杜志明. 桥丝式电火工品热点火理论[J]. 火工品, 2007(4):26-30.
相关信息