搜索热:失效分析 陶瓷
扫一扫 加微信
首页 > 期刊论文 > 论文摘要
35CrMo钢在含砂胍胶溶液中的冲刷腐蚀行为和机理
          
Erosion Corrosion Behavior and Mechanism of 35CrMo Steel in Solution Containing Guargum and Sand

摘    要
采用失重法、微观形貌观察法和电化学法研究了35CrMo钢在胍胶溶液、含砂水溶液和含砂胍胶溶液中的冲刷腐蚀行为和机理。结果显示:溶液的侵蚀性由高到低排序为含砂胍胶溶液、含砂水溶液和胍胶溶液;在含砂水中加入胍胶可明显抑制冲刷腐蚀;相比于胍胶溶液,35CrMo钢在含砂胍胶溶液中腐蚀电流密度的增大说明砂粒的存在能显著提高由力学作用引起的腐蚀增量。
标    签 冲刷腐蚀   交互作用   高黏度   液固冲蚀   erosion corrosion   synergetic action   high viscosity   liquid-solid erosion  
 
Abstract
The erosion corrosion behavior and mechanism of 35CrMo steel in guanidine gum solution, sand water solution and sand guanidine gum solution were investigated by weight-loss method, microstructure observation, and the electrochemical method. The results showed that the descending order of solution erodibility was as following:sand guanidine gum solution, sand water solution and guanidine gum solution. Guanidine gum added into the sand water solution could reduce erosion corrosion. The corrosion current density of 35CrMo steel was higher in the sand guanidine gum solution than in the guanidine gum solution, indicating that the presence of sand can significantly raise the corrosion increment caused by mechanical action.

中图分类号 TG172   DOI 10.11973/fsyfh-202305003

 
  中国光学期刊网论文下载说明


所属栏目 试验研究

基金项目 国家自然科学基金面上项目(51971229);中国科学院核用材料与安全评价重点实验室开放课题项目(2019NMSAKF02)

收稿日期 2021/12/14

修改稿日期

网络出版日期

作者单位点击查看


引用该论文: FU Dengwei,ZHENG Kexin,LI Bolun,REN Qiannan,QIU Fushou,HU Hongxiang,ZHENG Yugui. Erosion Corrosion Behavior and Mechanism of 35CrMo Steel in Solution Containing Guargum and Sand[J]. Corrosion & Protection, 2023, 44(5): 13


论文评价
共有人对该论文发表了看法,其中:
人认为该论文很差
人认为该论文较差
人认为该论文一般
人认为该论文较好
人认为该论文很好
分享论文
分享到新浪微博 分享到腾讯微博 分享到人人网 分享到 Google Reader 分享到百度搜藏分享到Twitter

参考文献
【1】李雪松. 中国油气井压裂井口保护器技术现状[J]. 非常规油气, 2016, 3(6):113-117.
 
【2】陈红. 一种新型酸压井口保护器[J]. 油气井测试, 2004, 13(5):95-96, 110.
 
【3】王尊策, 张书进, 庞鑫峰, 等. 压裂管柱内突扩两相湍流数值模拟[J]. 科学技术与工程, 2009, 9(22):6776-6778, 6789.
 
【4】王尊策, 张书进, 庞鑫峰, 等. 压裂管柱内突扩两相湍流数值模拟[J]. 科学技术与工程, 2009, 9(22):6776-6778, 6789.
 
【5】张书进. 压裂管柱内固液两相流动特性及磨损机理研究[D]. 大庆:大庆石油学院, 2010.
 
【6】ZHANG L M, MA A L, HU H X, et al. Effect of microalloying with Ti or Cr on the corrosion behavior of Al-Ni-Y amorphous alloys[J]. Corrosion, 2018, 74(1):66-74.
 
【7】E M, HU H X, GUO X M, et al. Comparison of the cavitation erosion and slurry erosion behavior of cobalt-based and nickel-based coatings[J]. Wear, 2019, 428/429:246-257.
 
【8】LIU M M, HU H X, ZHENG Y G. Effects of three sealing methods of aluminum phosphate sealant on corrosion resistance of the Fe-based amorphous coating[J]. Surface and Coatings Technology, 2017, 309:579-589.
 
【9】HU H X, ZHENG Y G. The effect of sand particle concentrations on the vibratory cavitation erosion[J]. Wear, 2017, 384/385:95-105.
 
【10】张福祥, 巴旦, 刘洪涛, 等. 压裂过程超级13Cr油管冲刷腐蚀交互作用研究[J]. 石油机械, 2014, 42(8):89-93.
 
【11】ZHANG J X, KANG J A, FAN J C, et al. Study on erosion wear of fracturing pipeline under the action of multiphase flow in oil & gas industry[J]. Journal of Natural Gas Science and Engineering, 2016, 32:334-346.
 
【12】DESALE G R, GANDHI B K, JAIN S C. Particle size effects on the slurry erosion of aluminium alloy (AA 6063)[J]. Wear, 2009, 266(11/12):1066-1071.
 
【13】HU H X, WANG Z B, CHEN J A. The effects of sand particles on the synergy of cavitation erosion-corrosion of MIG welding stainless steel coating in saline water[J]. Scanning, 2020, 2020:1-10.
 
【14】郑玉贵, 姚治铭, 李生春, 等. 泥浆型冲蚀中冲刷和腐蚀的交互作用[J]. 中国腐蚀与防护学报, 1993, 13(4):390-395.
 
【15】李强. 管线钢油/水/砂多相流冲刷局部腐蚀研究[D].青岛:中国石油大学(华东), 2013.
 
【16】张安峰, 王豫跃, 邢建东, 等. 两种涂层和两种钢在液/固两相流中冲刷与腐蚀的交互作用[J]. 金属学报, 2004, 40(4):411-415.
 
【17】GUO H X, LU B T, LUO J L. Interaction of mechanical and electrochemical factors in erosion-corrosion of carbon steel[J]. Electrochimica Acta, 2005, 51(2):315-323.
 
【18】GUO H X, LU B T, LUO J L. Study on passivation and erosion-enhanced corrosion resistance by Mott-Schottky analysis[J]. Electrochimica Acta, 2006, 52(3):1108-1116.
 
【19】LU B T, LUO J L, GUO H X, et al. Erosion-enhanced corrosion of carbon steel at passive state[J]. Corrosion Science, 2011, 53(1):432-440.
 
【20】NEVILLE A, HU X. Mechanical and electrochemical interactions during liquid-solid impingement on high-alloy stainless steels[J]. Wear, 2001, 251:1284-1294.
 
【21】王军军, 李志均, 黄伟九. 沙粒粒径和外电位对黄铜腐蚀磨损的影响[J]. 摩擦学学报, 2016, 36(4):406-412.
 
【22】HUMPHREY J A C. Fundamentals of fluid motion in erosion by solid particle impact[J]. International Journal of Heat and Fluid Flow, 1990, 11(3):170-195.
 
【23】CLARK H M. On the impact rate and impact energy of particles in a slurry pot erosion tester[J]. Wear, 1991, 147(1):165-183.
 
【24】KESANA N R, THRONEBERRY J M, MCLAURY B S, et al. Effect of particle size and liquid viscosity on erosion in annular and slug flow[J]. Journal of Energy Resources Technology, 2014, 136(1):012901.
 
【25】CHEN Z X, HU H X, ZHENG Y G, et al. Effect of groove microstructure on slurry erosion in the liquid-solid two-phase flow[J]. Wear, 2021, 466/467:203561.
 
【26】计时鸣, 马宝丽, 谭大鹏. 结构化表面环境下软磨粒流的流场数值分析[J]. 光学精密工程, 2011, 19(9):2092-2099.
 
【27】KESANA N R, GRUBB S A, MCLAURY B S, et al. Ultrasonic measurement of multiphase flow erosion patterns in a standard elbow[J]. Journal of Energy Resources Technology, 2013, 135(3):032905.
 
相关信息
   标题 相关频次
 温度变化对干耦合压电腐蚀监测的影响及其补偿方法
 8
 5 Mt/a常减压装置常顶空冷出口集合管腐蚀泄漏原因及防腐蚀建议
 2
 Ni-P-Al2O3镀层的腐蚀、冲刷腐蚀和磨损行为
 2
 P110油管腐蚀穿孔原因分析
 2
 船舶冷却系统铜镍合金管腐蚀穿孔原因
 2
 核电厂板式热交换器的泄漏原因
 2
 核电厂二回路管道腐蚀降级特征分析与敏感点识别
 2
 核电厂海水循环泵用两种耐腐蚀涂层
 2
 换热器波纹管的腐蚀失效原因
 2
 集气管线带焊缝90°弯头的冲刷腐蚀
 2
 甲胺装置换热器管束的泄漏失效分析
 2
 铝青铜在不同流速海水泥浆下的冲刷腐蚀行为
 2
 某天然气站场管道典型管件内腐蚀原因分析
 2
 凝析气田集输管道弯管冲刷腐蚀数值计算
 2
 凝析气田集输管线冲刷腐蚀与防护问题
 2
 胜利油田某油井盲管腐蚀穿孔的原因
 2
 苏里格气田东区站场排液管线的腐蚀风险及其防治措施
 2
 循泵旋转滤网系统冲洗水管道泄漏原因分析
 2
 油田注水系统管路腐蚀及主控因素研究
 2
 90°竖直弯管的液固两相流冲刷腐蚀模拟
 1
 Cr含量对WC基硬质合金耐腐蚀性能的影响
 1
 HSn70-1船用冷凝管腐蚀穿孔失效分析
 1
 N80钢在含沙和含Cl-溶液中的冲刷腐蚀行为
 1
 奥氏体不锈钢AL-6XN在超临界水中的腐蚀行为
 1
 管道弯头穿孔失效分析
 1
 含砂NaCl水溶液中流速对N80钢冲刷腐蚀行为的影响
 1
 火力发电厂凝汽器铜管冲刷腐蚀原因
 1
 基于FLUENT和神经网络预测海水弯管冲刷腐蚀的模型
 1
 基于多因子交互作用的PP/EPDM复合材料注射成型工艺优化
 1
 加氢裂化空冷器管束失效的多相流数值分析
 1