形变铝合金的形变硬化特性

详细信息

DEFORMATION HARDENING BEHAVIORS OF DEFORMED ALUMINUM ALLOYS

摘要: 采用单轴拉伸方法测试了LD10,LF6,LC4和LY12几种形变铝合金的形变硬化指数,分析了合金的硬化率和硬化指数与应变的关系。结果表明,这几种形变铝合金的硬化指数在不同的应变区域具有不同的变化趋势。在低应变区域,形变硬化指数呈上升趋势,在高应变区域,形变硬化指数趋于平稳。四种形变铝合金中,LF6的硬化指数最高,LY12,LD10次之,LC4最低。形变铝合金的硬化率随着应变的增加不断降低。
- 形变铝合金 /
- 应变硬化指数 /
- 硬化率
Abstract: The strain hardening exponents of four kinds of deformed aluminums alloy (LD10,LF6,LC4 and LY12) were measured by uniaxial tensile testing,and the relations of hardening exponent and hardening rate with strain were analyzed. It was found that the hardening exponents of the four kinds of deformed aluminum alloy had various changing tendency in different strain sections,rising in low strain section and stabilizing in high strain section. Of which,the hardening exponent of LF6 was highest,and that of LC4 was lowest,and that of LY12 and LD10 were in middle. The hardening rates declined with increasing strain.
- Deformed aluminum alloy /
- Strain hardening exponent /
- Hardening rate

[1]	宋玉泉,海锦涛,管志平.拉伸形变应变硬化指数的力学解析［J］.中国科学,2001,31(2):103-108．
[2]	刘文昌,张静武,郑炀曾.氮强化高锰奥氏体不锈钢的应变硬化行为［J］.金属热处理学报,1995,16(3):33-38．
[3]	宋玉泉,程永春,刘颖,等.拉伸形变应变硬化指数的力学含义及其规范测量［J］.中国科学,2000,30(3):200-207．
[4]	张旺风,卢正欣,陈瑜眉.组织结构对应变硬化的影响［J］.机械工程材料,2002,26(10):7-9．